Pinnacle IKONIC Slimline DKL067, Manual

Slimline Combination Entrance Set

Step 1: Preparation

Cut template on line (A) & fold on line (B) 
as shown. Place on door at your preferred 
height and mark both the latch height 
(C) and centre of handle hole (D) with a 
pencil. Remove template, and measure 
the thickness of door to mark the centre 
point of the door edge. Use a 25mm 
spade bit to drill an accurate hole through 
the door edge, and using a hole saw, drill 
a 54mm hole through the door front.
Accuracy is vital so mark and measure 
carefully and drill holes level.

Step 2: Installing the Latch

Place Latch (E) into the 25mm hole 
on the side of the door and mark 
the door around the square plate 
with a pencil. Using a hammer and 
a chisel check out the timber so 
that the latch fits into the newly 
created recess and finishes flush 
with door. Once completed push 
latch into place and drill 2mm pilot 
holes into the door edge, simply 
use screwdriver to insert the timber 
screws included.

Instructions to install this Slimline entrance lever set

If installing this entrance set into a new door you will need the following tools - 25mm spade bit, 2mm drill bit, 54mm hole saw, corded or cordless drill, hammer, wood chisel, 
Phillips head screwdriver, tape and pencil. If you are replacing an existing lever you shouldn’t require the drill, hole saw or spade bit as this lever will replace most standard levers.

Very Important! 

This Slimline entrance lever set is designed to suit either left or right hand opening doors.
Please fasten all screws by hand and not an electric screw driver or drill, as over tightening is not recommended.

Step 3: Attaching the levers to door.

Insert the lever handle with spindle (F) through the door 
hole and into the latch (E). Now insert the two screws (K) 
through from inside the room and tighten firmly.

How to convert latch from 60mm to 70mm 

Slide tab from the marked 60mm position to the 70mm position.

Line B

Line A

C

D

60mm

(or 70m

m)

Tip: Before closing the door, 
check that the operation of the 
handle functions correctly.

Move tab from 

60mm to 70mm