Pintech usa inc
27 american court
GREENVILLE, SC 29609
1 800 445 0506
WWW.PINTECHWORLD.COM
PLAY
@
EDRUMS.COM
SETUP PROCEDURE
1. ASSEMBLE RACK
2. INSTALL DRUMS AND CYMBALS TIGHTLY
3. CABLE CONNECTIONS;
a. BLUE (STEREO) CABLE MUST GO TO CONTROL PEDAL
b. LET THE CABLE LENGTHS DETERMINE THE REMAINING
CONNECTIONS
4. TUNING CYMBALS/DRUMS (USING HEADPHONES)
a. TENSION HEADS AS NECESSARY TO ELIMINATE ‘SOFT
SPOTS’
b. PUSH ‘UTILITY’
c. LEAVE ‘SelfRej’ AND ‘Rej’ AT DEFAULT SETTINGS UNLESS
ABSOLUTELY
NECESSARY
d. PUSH ‘Page +’
e. ADJUST GAIN TO 0 (by turning knob)FOR ALL
CYMBALS/DRUMS
f. PUSH ‘Page +’
g. ADJUST ‘Velcurve:’ to ‘Hard 2’ (by turning knob)
h. PUSH ‘KITS’ TO EXIT AND SAVE SETTINGS
5. AMPLIFIER SETUP
a. STEREO AMPLIFIERS
i. A STEREO CABLE FROM ‘AUX OUT’ TO A STEREO
INPUT REQUIRES NO MODULE SETTING ADJUSTMENT
ii. A STEREO SPLITTING CABLE (TIP, RING, SLEEVE
SPLITTER) IS REQUIRED TO SEND ‘LEFT’ AND ‘RIGHT’
SEPARATE CHANNELS TO DUAL INPUT AMPLIFIERS
b. MONO AMPLIFIERS
i. ALL INSTRUMENTS SHOULD BE ‘PANNED’ LEFT FOR
MAXIMUM PERFORMANCE
1. PUSH ‘VOICE’
2. PUSH ‘PAGE +’ TWICE
3. PUSH ‘SELECT’ (PAN: # SHOULD BLINK)
4. TURN KNOB SO ‘Pan:0’ (0=FULL LEFT)
5. SAVE ALL CHANGES TO A USER KIT (ANY # 21
THRU 30) BY PUSHING ‘SAVE/ENTER’ TWICE
6. PUSH ‘KIT’ AND SELECT THE KIT THE CHANGES
WERE SAVED TO USING KNOB
