4
5. Install the back cushion and seat cushion.
Remove nuts from underside of seat, attach to the seat
post and secure in place using the spanner provided.
Attach seat back to the upright section of the seat post
using two screws and allen key provided.
7. Install the resistance knob.
Add the front of the resistance dial cover over the resistance
dial and onto the handlebar. Tuck the wires to the monitor into
a position, so they are not going to be damaged. Take the
back place of the resistance dial cover and position it in place.
Secure with the 5 small screws provided and screwdriver.
8. Install the workstation tray.
To add the workstation tray. Place the handle bars, so
they are parallel with the floor. Push the tray onto the
handle bar using the clips on the underside of the work-
station tray.
6. Install the front handlebar and console.
Insert front handlebar onto main frame using the support
hinge already attached. Make sure the notch on the
handlebar is facing outwards to allow the handlebar to
be adjusted.
Take the monitor and place on top of the front handlebar.
Secure with small screw. Make sure not to trap any of
the wires from the monitor. Connect wires of monitor to
handlebar wires. Making sure the 2 pins are slotted into
the connector the right way round.
