9
Figure 5
Instructions for Connection to the Power Supply (230V)
CAUTION:
This machine will operate only on the AC frequency and electrical voltage shown on the nameplate.
Make sure you have the correct frequency and voltage before connecting the power cord to an outlet.
This machine must be connected to the electrical ground to protect the operator from electric shock. The machine has
a power cord with two main conductors and one earthing conductor. Connect the plug to the type of receptacle shown
in figure 5. The green and yellow conductor cord is the ground wire. Never connect this wire to any terminal other
than the ground terminal.
WARNING:
Always use this machine with an AC three-conductor electrical system connected to the electrical
ground. Replace any worn, cut, or damaged cords. Peplace any damaged plugs, receptacles, or
connector bodies. Do not move the machine over an electrical cord. Always lift the cord over the
machine.
Extension Cords (230V)
Use only an approved extension cord with two main conductors and one earthing conductor.
WARNING:
If you use an extension cord, use an extension cord with minimum wire size 1.55 mm2. Do not use
an extension cord longer than 15 meters. Do not join two extension cords.
WARNING:
Do not cut, remove, or break the ground terminal. Do not try to fit a three-terminal plug into a recepta-
cle or connector body that does not fit the plug. If the receptacle or connector body does not fit the plug, see your
Authorized person to make the connection.
Summary of Contents for PE225FP
