Important
!
Handle gently when removing or attaching
the front panel.
!
Avoid subjecting the front panel to excessive
shock.
!
Keep the front panel out of direct sunlight and
high temperatures.
!
If removed, replace the front panel on the unit
before starting up your vehicle.
Removing the front panel
%
Pinch the top and bottom of its right
side and pull the front panel out.
Take care not pinch it too tightly or to drop it,
and also avoid contact with water or other
fluids to prevent permanent damage.
Attaching the front panel
1
Slide the front panel to the left.
Front panel and the head unit are jointed on
the left side. Make sure that the front panel
has been jointed to the head unit.
2
Press the right side of the front panel
until it is firmly seated.
#
If you can
’
t attach the front panel to the head
unit successfully, try again. Front panel may be
damaged if you attach the front panel forcedly.
Resetting the microprocessor
Pressing
RESET
lets you reset the micropro-
cessor to its initial settings without changing
the bookmark information.
The microprocessor must be reset under the
following conditions:
!
Prior to using this unit for the first time
after installation
!
If the unit fails to operate properly
!
When strange or incorrect messages ap-
pear on the display
1
Turn the ignition switch OFF.
2
Remove the front panel.
Refer to
Removing the front panel
on this page.
3
Press RESET with a pen tip or other
pointed instrument.
RESET
button
Note
After completing connections or when you want
to erase all memorized settings or return the unit
to its initial (factory) settings, switch your engine
ON or set the ignition switch to ACC ON before
pressing
RESET
.
Before You Start
En
12
Section
02