!
LEVEL 1
Playback of discs for children
only is possible
Notes
!
We recommend to keep a record of your code
number in case you forget it.
!
The parental lock level is recorded on the disc.
You can confirm it by looking at the disc pack-
age, included literature or on the disc itself.
With discs that do not feature a recorded par-
ental lock level, you cannot use parental lock.
!
With some discs, parental lock operates to
skip certain scenes only, after which normal
playback resumes. For details, refer to the
disc
s instructions.
Changing the level
You can change the set parental lock level.
1 Touch SETUP and VISUAL and then
touch PARENTAL.
2 Touch 0
9 to input the registered code
number.
3 Touch ENTER.
This enters the code number, and you can now
change the level.
#
If you input an incorrect code number, the
icon
is displayed. Touch
C
and input the cor-
rect code number.
#
If you forget your code number, refer to
4 Touch any of 1
8 to select the desired
level.
The new parental lock level is set.
If you forget your code number
Refer to
on this page, and
touch
C
10 times. The registered code number
is canceled, letting you register a new one.
Setting remote control
code type
When the remote control operation switch is
set to
DVD
, changing the remote control code
type enables you to operate the Pioneer DVD
player by the supplied remote control. There
are three remote codes, code type
A
, code
type
B
and code type
AVH
. When using this
unit with a multi-DVD player (e.g. XDV-P9II),
select code
A
. When using this unit with a
DVD navigation unit, select code
B
. When
using this unit only, select code
AVH
.
1 Set the remote control selection switch
on the left side of the remote control to
the appropriate position with a pen tip or
other pointed instrument .
!
If you select
AVH
mode, there is no need to
take the following procedure.
!
If you select
A
/
B
mode, take the following
procedure and change the code type to the
appropriate type.
2 Press 7 and 0 on the remote control si-
multaneously to change the code type.
Initially, the code type is set to
A
. Each time
you press
7
and
0
simultaneously on the re-
mote control the code type switches between
A
and
B
.
Setting up the DVD player
En
85
Section
17
Setting
up
the
DVD
player
