Using the direct control
You can override audio settings to check for ef-
fectiveness of your audio settings.
!
All audio functions are locked out during
the direct control is on except
VOLUME
.
1 Touch A.MENU and AUDIO and then
touch DIRECT.
2 Touch
a
to turn the direct control on.
#
To turn direct control off, touch
b
.
Using the Dolby Pro Logic
Dolby Pro Logic gives enhanced spatial and di-
rectional effects, creating theater-like sense of
presence and ambience.
!
If the source is a 2-channel LPCM audio or
a 2-channel Dolby Digital audio and you se-
lect SFC effects that are most applicable
for 5.1-channel audio (i.e.,
MUSICAL
,
DRAMA
or
ACTION
), we recommend turn-
ing Dolby Pro Logic on. On the other hand,
when selecting SFC effects that are in-
tended for use with 2-channel audio (i.e.,
JAZZ
,
HALL
or
CLUB
), we recommend turn-
ing Dolby Pro Logic off.
1 Touch A.MENU and AUDIO and then
touch NEXT.
2 Touch DOLBY PL.
3 Touch
a
to turn the Dolby Pro Logic on.
#
To turn Dolby Pro Logic off, touch
b
.
Note
When playing a 2-channel mono source with Pro
Logic turned on, there may be occasions when
the following will occur:
!
No audio is output if the center speaker set-
ting is
SMALL
or
LARGE
and no center speak-
er is installed.
!
Audio is heard only over the center speaker if
installed and the center speaker setting is
SMALL
or
LARGE
.
Setting the speaker setting
You need to make with/without (or yes/no) and
size (bass reproducing capacity) selection/ad-
justments depending on the installed speak-
ers. The size needs to be set to
LARGE
(large)
if the speaker is capable of reproducing
sounds of about 100 Hz or below. Otherwise
select
SMALL
(small).
!
Low frequency range is not output if the
subwoofer is set to
OFF
and the front and
rear speakers set to
SMALL
or
OFF
.
!
It is imperative that non-installed speakers
be set to
OFF
.
!
Set the front or rear speaker to
LARGE
if
the speaker is capable of reproducing bass
content, or if no subwoofer is installed.
1 Touch A.MENU and AUDIO and then
touch NEXT.
2 Touch SP SET.
3 Touch
a
or
b
to select the speaker to
be adjusted.
Each time you touch
a
or
b
selects the speak-
er in the following order:
FRONT
(front speakers)
CENTER
(center
speaker)
REAR
(rear speakers)
SUB WOOFER
(subwoofer)
PHASE
(sub-
woofer setting)
#
You can switch to
PHASE
only when the sub-
woofer has been set to
ON
.
DigitalSignalProcessor
En
77
Section
16
DigitalSignalProcessor