Adjusting the speaker
output levels
You can readjust the speaker output levels
using a test tone while listening to music.
1 Touch A.MENU and AUDIO and then
touch NEXT.
2 Touch SP LEVEL.
3 Touch
a
or
b
to select the speaker to
be adjusted.
Each time you touch
a
or
b
selects the speak-
er in the following order:
FRONT L
(front speaker left)
CENTER
(center
speaker)
FRONT R
(front speaker right)
REAR R
(rear speaker right)
REAR L
(rear
speaker left)
SUB WOOFER
(subwoofer)
#
You cannot select speakers whose size is set
OFF
.
4 Touch
c
or
d
to adjust the speaker out-
put level.
Each time you touch
c
or
d
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
Note
To adjust the speaker output levels at this mode is
the same as making the speaker output levels at
TEST TONE
. Both provide the same results.
Adjusting the speaker output
levels using a test tone
A convenient test tone allows you to easily get
the overall balance right among the speakers.
1 Touch A.MENU and AUDIO and then
touch NEXT.
2 Touch TEST TONE.
3 Touch START to start the test tone out-
put.
The test tone is output. It rotates from speaker
to speaker in the following sequence at inter-
vals of about two seconds. The current set-
tings for the speaker over which you hear the
test tone are shown in the display.
FRONT L
(front speaker left)
CENTER
(center
speaker)
FRONT R
(front speaker right)
REAR R
(rear speaker right)
REAR L
(rear
speaker left)
SUB WOOFER
(subwoofer)
Check each speaker output level. If no adjust-
ments are needed, perform step 5 to stop the
test tone.
#
You can also start the test tone output by mov-
ing the joystick up.
#
The settings do not appear for speakers
whose size is set
OFF
.
4 Touch
c
or
d
to adjust the speaker out-
put level.
Each time you touch
c
or
d
increases or de-
creases the speaker output level.
+10
10
is
displayed as the level is increased or de-
creased.
#
The test tone rotates to the next speaker after
about two seconds from the last operation.
5 Touch STOP to stop the test tone out-
put.
#
You can also stop the test tone output by mov-
ing the joystick down.
Notes
!
If needed, select speakers and adjust their
ab-
solute
output levels. (Refer to
!
To adjust the speaker output levels at this
mode is the same as making the speaker out-
put levels at
SP LEVEL
. Both provide the same
results.
DigitalSignalProcessor
En
79
Section
16
DigitalSignalProcessor