< CRD4846-A >
English
3
En
Connecting the power cord
Aerial jack
Vehicle Bus adapter input
Please refer to the instruction manual for the Vehicle Bus adapter (sold separately).
Power supply
Power cord
Vehicle Bus conversion cable 15.8 cm
Connection method
1. Clamp the lead.
2. Clamp firmly with
needle-nosed pliers.
Note:
· The position of the parking brake switch depends on the vehicle model. For details,
consult the vehicle Owner’s Manual or dealer.
Yellow/black
If you use an equipment with Mute function, wire this lead to the Audio Mute lead on
that equipment. If not, keep the Audio Mute lead free of any connections.
Light green (PARKING BRAKE)
Used to detect the ON/OFF status of the parking brake. This lead
must be connected to the power supply side of the parking brake
switch.
Blue/white
Connect to system control terminal of the
power amp (max. 300 mA 12 V DC).
Blue/white
(6*)
Connect to auto-antenna relay control terminal
(max. 300 mA 12 V DC).
The pin position of the ISO
connector will differ depending on
the type of vehicle. Connect 5* and
6* when Pin 5 is an antenna control
type. In another type of vehicle,
never connect 5* and 6*.
Blue/white
(5*)
Ground side
Power supply side
Parking brake
switch
ISO connector
Note:
In some vehicles, the ISO connector may be divided into
two. In this case, be sure to connect to both connectors.
Note:
Depending on the kind of vehicle,
the function of 2* and 4* may be
different. In this case, be sure to
connect 1* to 4* and 3* to 2*.
1*
3*
2*
4*
Connect leads of the same
color to each other.
This product
Microphone
Violet/white
Of the two lead wires connected to the back lamp, connect the one in which the
voltage changes when the gear shift is in the REVERSE (R) position. This connection
enables the unit to sense whether the car is moving forwards or backwards.
4 m
Please contact your dealer to
inquire about the connectable
navigation unit.
Wired remote input
Hard-wired remote control adapter can be connected (sold separately).
Speaker leads
White:
Front left
White/black:
Front left
Gray:
Front right
Gray/black:
Front right
Green:
Rear left
Green/black: Rear left
Violet:
Rear right
Violet/black:
Rear right
Pioneer
navigation
system
RGB cable (supplied with navigation system)
Fuse (10 A)
Yellow
(2*)
Back-up
(or accessory)
Yellow
(1*)
Connect to the constant 12 V
supply terminal.
Red
(4*)
Accessory
(or back-up)
Red
(3*)
Connect to terminal controlled by
ignition switch (12 V DC).
Black (ground)
To vehicle (metal) body.
Orange/white
To lighting switch terminal.
Note
Make sure to connect the microphone supplied with this product when using
Android Auto
.
CRD4846-A̲3
Summary of Contents for AVH-X8700BT
