15
Steering Wheel Control
1. Touch [Steering Wheel Control], the SWC menu will display.
2. There are 9 default keys, and you can also set the function
that you want.
Setting step as below:
1. Touch [Clear] to reset the dafault keys, and display as below:
2. Touch any key the current function key turns bright.
3. The function menu is displayed, as below:
AV Source /
/
/
/
/ / / / /Band
4. Select one function key that you want.
• For example press [AV Source] on the function menu.
5. Display below picture and according to the prompt operate.
6. Press each individual steering wheel control button for each
corresponding function.
7. When success, the currect interface return to the previous
menu automatically.
8. If you don’t select, touch [Cancel] to cancel.
9. The other keys setting operation same to the [AV Source]
key.
10. Once the final steering wheel control button is programmed,
the functions are saved and the programming will end.
Settings
Adjust Audio settings
1. Touch [
].
2. Touch to highlight a setting.
3. Touch to display/select an option.
4. Touch [ ] on the upper right of the screen to exit.
Fader/
Balance
(Front speaker)
Adjust fader/
balance value
from 0 to 12.
(Rear speaker)
(Left speaker)
(Right speaker)
Graphic EQ
Refer to "Graphic EQ" on page 15.
Loudness
Off (default) Select low frequency boost
only or high and low frequency
boost.
Low
High
Subwoofer
Subwoofer
On (default)
Select
subwoofer On
or Off.
Off
Level
Adjust level value from -24 to
+6.
Frequency
80 Hz (default) Select a
crossover
frequency to
set a cutoff
frequency
for the
subwoofer’s
LPF (low-pass
filter).
120 Hz
160 Hz
Source Level
Adjuster
Refer to "Source Level Adjuster" on page 15.
DRC
On (defailt) Set the DRC
(Dynamic Range Control) On
or off.
Off
Graphic EQ
Select Preset Equalizer
1. Enter the EQ setup mode
Touch the [Graphic EQ] in Audio setting menu and the EQ
setup interface will display on the screen.
2. Touch [ ] / [ ] to adjust the level of [BASS] / [MID] / [TRE].
Select EQ mode
Touch the desired EQ selection: [S.BASS] / [Powerful] /
[Natural] / [Vocal] / [Flat] / [Custom], and the EQ mode will
change.
Notes:
• The EQ mode will change to ‘Custom’ automatically when you
adjust the frequency value in all modes besides ‘Custom’.
• The value of Sub is independent of EQ mode and can be adjusted
separately.
Source Level Adjuster
SLA (source level adjustment) lets you adjust the volume level
of each source to prevent radical changes in volume when
switching between sources.
Touch [ ] / [ ] to increases / decreases the source volume.
Notes:
• If you directly touch the area where the cursor can be moved, the
Source Level Adjuster setting will be changed to the value of the
touched point.
• The scope of adjustment: -4 to +4.
• Settings are based on the FM tuner volume level, which remains
unchanged.
• This function is not available when the FM tuner is selected as the
AV source.
Adjust Video Settings
1. Touch [
].
2. Touch to highlight a setting.
3. Touch to display/select an option.
4. Touch [ ] on the upper right of the screen to exit.
