When the gear lever is shifted to
“
R
”
, the
signal switches to
“
High
”
or
“
Low
”
. (One of
these is displayed depending on the
vehicle.)
Checking sensor learning
status and driving status
p
The navigation system can automatically
use its sensor memory based on the outer
dimensions of the tyres.
1
Display the
“
Navi Settings
”
screen.
=
For details, refer to
2
Touch [3D Calibration Status].
The
“
3D Calibration Status
”
screen appears.
2
3
4
5
1
6
7
1
Speed
Indicates the speed detected by the naviga-
tion system. (This indication may be differ-
ent from the actual speed of your vehicle,
so please do not use this instead of the
speedometer.)
2
Acceleration or deceleration/Rotational
speed
Indicates acceleration or deceleration velo-
city of your vehicle. Also, rotational speed
when your vehicle turns to left or right is
shown.
3
Distance
Indicates driving distance.
4
Speed Pulse
Indicates the total number of speed pulses.
5
Learning Status
Indicates the current driving mode.
6
Inclination
Indicates the degree of slope of the street
that you are currently on.
7
Degree of learning
Sensor learning situations for distance
(
Distance
), right turn (
Right Turn
), left turn
(
Left Turn
) and 3D detection (
3D Detec-
tion
) are indicated by the length of bars.
p
When tyres have been changed or
chains fitted, turning on the Speed
Pulse allows the system to detect the
fact that the tyre diameter has changed,
and automatically replaces the value for
calculating distance.
p
If a separately sold speed pulse genera-
tor (ND-PG1) is connected, the distance
calculation value cannot be replaced
automatically.
Clearing status
You can delete the learned results stored in
[
Distance
], [
Speed Pulse
] or [
Learning Sta-
tus
].
1
Touch [Distance] or [Speed Pulse].
The following message appears.
2
Touch [Yes].
Clears the results stored in [
Distance
] or
[
Speed Pulse
].
3
Touch [Learning Status].
The following message appears.
Engb
117
Chapter
26
Customising
pr
eferences
Customising preferences
