117
Appendix
NAVI/AV
Your vehicle is operating in Simple
hybrid mode.
Connect the speed signal input (pink
lead wire) of the power cable cor-
rectly, and reset the 3D Hybrid Sen-
sor memory (“
Learning Status
”).
The navigation unit is installed with
an extreme angle exceeding the limi-
tation of the installation angle.
Confirm the installation angle. (This
unit must be installed 30
degrees to –30 degrees of the hori-
zontal, or within five degrees of your
vehicle’s direction of travel.)
Indication of the position of your
vehicle is misaligned after a U-turn or
reversing.
Check whether or not the reverse
gear signal input lead (purple) is con-
nected properly. (The Navigation Sys-
tem works properly without the lead
connected, but positioning accuracy
will be adversely affected.)
The map continually reorients itself.
The traveling direction is always set
to north.
Touch
on the screen and change
the map display.
Tracking marks are not displayed.
The “
Tracking Display
” is turned
off.
Check the “
Tracking Display
” set-
tings (
➞
Page 66) and make sure
“
Always
” or “
This Trip
” is selected.
The daylight display is used even
when the vehicle lights are on.
Daytime is selected on “
Day/Night
Display
”.
Check the “
Day/Night Display
” set-
ting (
➞
Page 66) and make sure
“
Nighttime
” is selected.
The Orange/white lead is not con-
nected.
Check the connection.
The system will not switch on or will
not operate.
Installation or connection has been
carried out incorrectly.
Check with your dealer.
The display is very dim.
The vehicle’s light is turned ON, and
“
Nighttime
” is selected on “
Day/
Night Display
”.
Read about the “
Day/Night Dis-
play
” setting (
➞
Page 66) and, if
desired, select “
Daytime
”.
The vehicle cabin temperature is
extremely low.
A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the vehi-
cle to warm up.
Picture quality adjustment of the dis-
play is not correct.
Refer to “Hardware Manual” to
adjust the picture quality.
Ambient light sensor of the display is
hidden.
Set the ambient light sensor not to
be hidden.
There is no voice guidance or the vol-
ume is low.
The volume setting is low or the
speaker lead is disconnected.
Check the volume setting on the dis-
play or turn the volume up according
to “
Volume
” (
➞
Page 63) and/or
turn up the volume on the display.
Slope
is not displayed on the
Vehicle Dynamics
screen.
Inclination
does not move on the
3D Calibration
screen.
The speed pulse lead is not con-
nected.
Connect the speed pulse lead.
When the screen is frozen...
Park your vehicle at a safe place, and cut the engine off. Turn the ignition key back to “Acc off”. Then
start the engine again, and turn the power to the navigation unit back on. If this does not solve the
problem, press the
RESET
button on the navigation unit.
Symptom
Cause
Action (See)
Summary of Contents for AVIC N2 - Navigation System With DVD player
Page 20: ...18 ...
Page 70: ...68 Chapter 5 Customizing Your Navigation System NAVI ...