123
Appendix
NAVI/AV
•No map data available on this
scale. Scaling up.
•No map data available on this
scale. Scaling down.
When the scale that had been previ-
ously displayed cannot be displayed
for the following reasons:
•The disc was ejected and the sys-
tem was changed to the memory
navi mode.
•In the memory navi mode, the map
was scrolled to outside the memory
area. Or the vehicle moved outside of
the memory area.
•The map was scrolled to areas not
stored on the map disc (unrecorded
areas). Or the vehicle moved to unre-
corded areas.
•The map was scrolled from unre-
corded areas to the memory area. Or,
the vehicle moved from unrecorded
areas to the memory area.
If the desired scale cannot be
selected, insert the map disc that
contains that area and then change
the scale.
Failure in the memory recovery proc-
ess.
Memory navigation is presently not
possible.
Failed to complete the recovery of the
memory area because the disc could
not be read for some reason, result-
ing in deletion of the memory.
•Clean the disc.
•Clean the DVD drive.
•Consult the Pioneer Local dealer if
this message persists.
The map data could not be stored.
Previous setting will be kept.
In case recovery was performed for
the memory area after failing to read
the disc data for some reason (The
memory area that was previously set
will be recovered).
•Clean the disc.
•Clean the DVD drive.
•Consult the Pioneer Local dealer if
this message persists.
This function is not available with the
current map disc.
In case the current position is “areas
not stored on the map disc (unre-
corded areas)” and an attempt was
made to zoom in to make the scale
0.5 mile or more.
Zoom in again after the vehicle
moves into an area stored on the
map disc.
Or, replace the map disc and try to
zoom in again.
Failed to save to memory. Please re-
enter setting.
In case the settings could not be
saved for some reason.
•Retry.
•Consult the Pioneer Local dealer if
this message persists.
Caution !
System detected improper connec-
tion of Parking Brake lead. Please
check your configuration for safety.
Please see Operation Manual for
more information regarding safe
operation.
•Parking brake lead is incorrectly
connected.
•For a certain period after the instal-
lation of your Navigation System.
•Confirm once more that their con-
nections are correct.
•Drive your vehicle for a while until
the sensor learning status “Initializ-
ing” is turned to “Simple Hybrid” or
“3D Hybrid”.
Message
When
What to do
Summary of Contents for AVIC N2 - Navigation System With DVD player
Page 20: ...18 ...
Page 70: ...68 Chapter 5 Customizing Your Navigation System NAVI ...