61
Chapter 4
Editing the Navigation Utilities
NAVI
❒
The Navigation System can automatically use
its sensor memory based on the outer dimen-
sions of the tires.
Checking the connections of
leads and installation positions
Check that leads are properly connected between
the navigation unit and the vehicle. Please also
check whether they are connected in the correct
positions.
1
Touch “Settings” in the Main menu, then
touch “Hardware Info”.
2
Touch “Connection Status”.
The Connection Status screen appears.
(1) Speed Pulse
The Speed Pulse value detected by this unit is
shown. “0” is shown while the vehicle is sta-
tionary.
(2) GPS Antenna
Indicates the connection status of the GPS
antenna, the reception sensitivity, and from
how many satellites the signal is received.
If the signal is received correctly, "
OK
" is dis-
played. If reception is poor, "
NOK
" appears.
(3) Installation Position
The Installation position of the navigation unit
is shown.
If installed correctly, "
OK
" appears. Indicates
whether the Installation position of the naviga-
tion unit is correct or not. When the naviga-
tion unit is installed with an extreme angle
exceeding the limitation of the installing
angle, “
Incorrect angle
” will be displayed.
When the angle of the navigation unit has
been changed, “
Excessive vibration
” will be
displayed.
(4) Parking Brake
When the parking brake is applied, “
On
” is
displayed. When the parking brake is
released, “
Off
” is displayed.
(5) Power Voltage
The power supply (reference value) provided
from the vehicle battery to this unit is shown.
If the voltage does not fall within the range of
11 to 15V, check that power cable connection
is correct.
(6) Illumination
When the headlights or small lamps of a vehi-
cle are on, “
On
” is displayed. (If the orange/
white lead is not connected, “
Off
” appears.)
(7) Back Signal
When the gear lever is shifted to “R”, the sig-
nal switches to “
High
” or “
Low
”. (Which of
these is displayed depends on the vehicle.)
Setting the Vehicle Dynamics
Display
You can change the values displayed by the
instruments on the left and right of the Vehicle
Dynamics Display.
Until the sensor's initial learning is complete,
only the voltage and clock are available.
1
Switch to the Vehicle Dynamics Display.
➲
Changing the map display mode
➞
Page 29
2
Touch the left or right instrument.
Touch keys are displayed.
3
Touch the items you want to display.
You can select the following items.
•
Voltage
Displays the power supply and voltage sup-
plied from the battery to this system.
•
Acceleration
:
Acceleration in a forward direction is dis-
played. The + sign indicates acceleration
while the - sign indicates deceleration.
•
Side Acceleration
:
Acceleration in a side direction such as when
turning, is displayed. The + sign indicates a
right turn, while the - sign indicates a left turn.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Summary of Contents for AVIC N2 - Navigation System With DVD player
Page 20: ...18 ...
Page 70: ...68 Chapter 5 Customizing Your Navigation System NAVI ...