84
AVIC-W8400NEX/XNUC
1
2
3
4
A
B
C
D
E
F
1
2
3
4
Legend:
… Key operation
… Operational state
… The content displayed on the DVD mechanism (video only)
8 characters data is sent to the product side (HOST) by UART communication.
EDC. Image of the test mode
[Note] Image is the same for both EDC1 and EDC2.
(1)
(2)
[Note] Eject can be effected any time during the
EDC test mode.
Eject
After completion of EJECT operation
(5)
[Note] The display is updated at 0.5 seconds interval until 0/1 layer is selected or Eject is effected.
Image of the LD power on time mode.
[Method of setting time designation]
Designate the digit by command (1) and (2). UP/DOWN of numbers by command (3) and (4).
Fix by command (5). Cancel by command (8).
[Note] If the power on time is 999999 hours or more, it is always reported as 999999 hours.
[Note] If the power on time is “*E** ****”, the value may not be correct due to the life of the flash memory.
(1)-(4)
EDC1/2 test mode
0000 0000
Layer 0 selection
Layer 1 selection
ID designation
EDC1/2 start
0000 0000
0100 0000
1003 0000
1103 0000
Layer 1:11** ****
[Note] ** **** is the ID designation value
EJECT operation
Test mode Eject
**** ****
LD power on time mode
0000 0000
CD LD power on
time indication
DVD LD power on
time indication
CD LD power on
time setting
10** ****
[Note] ** **** is the CD LD
power on time.
20** ****
[Note] ** **** is the DVD LD
power on time.
Setting time
designation
30** ****
[Note] ** **** is the setting time.
Setting time
registration
DVD LD power on
time setting
Setting time
designation
40** ****
[Note] ** **** is the setting time.
Setting time
registration
(1)
(2)
(5)
(6)
(1)-(4)
(1)-(4)
(5)
(5)
(8)
(8)
10** ****
[Note] ** **** is the CD LD
power on time.
20** ****
[Note] ** **** is the DVD LD
power on time.
Layer 0:10** ****
[Note] ** **** is the present ID designation value
[Note] **** **** is the present ID designation value
Layer 1:21** ****
Layer 0:20** ****
Legend:
… Key operation
… Operational state
… The content displayed on the DVD mechanism (video only)
8 characters data is sent to the product side (HOST) by UART communication.