89
AVIC-W8400NEX/XNUC
5
6
7
8
5
6
7
8
A
B
C
D
E
F
When unplugging the Coaxial Jumper, make sure to use jig GGF1539.
If the antenna cable is directly unplugged without using jig GGF1539, you might damage your fingertip or fingernail.
- -
How to Remove the Coaxial Jumper
- -
When unplugging Coaxial Jumper, hook the point of jig GGF1539 on the lid of Coaxial Jumper
- -
and vertically draw out along with the engagement axis of connector.
- -
How to Attach the Coaxial Jumper
- -
For inserting Coaxial Jumper, adjust antenna cable with the engagement axis of connector and insert it as
- -
vertically as possible.
- -
Do not insert the Coaxial Jumper in extreme slant, as the connector might suffer damage.
Connector
Coaxial Jumper
GGF1539
Attach the bracket so that it exits to the outside of the side bracket.
Attention at assembly
Set the cable on the left side of the connector.
· About wiring arrangement of the cable (CDP1768) between the Service IF Unit and the AV unit
NG
OK
· About wiring arrangement of Coaxial Conn-Cable
Thread the black wire through the notch of the Service ANT Unit, then pass the gray line.
Service ANT Unit