!
ATT
—
Attenuation
!
Normal
—
Volume does not change
p
Operation returns to normal when the cor-
respond action is ended.
p
When
“
SD
”
or
“
USB
”
selected as the AV
source, the sounds are not muted or attenu-
ated even when the navigation guidance
and beep outputs.
p
When
“
SD
”
or
“
USB
”
is selected as the AV
source, the AV sounds, the navigation gui-
dance and beep sounds are mixed and the
volume can be adjusted simultaneously.
Important Notice regarding Volume of
Navigation Voice Guidance when Playing
Audio Files from USB or SD
If music files stored on an external storage device
(USB, SD) are played when the system guides the
route (i.e., a destination has been selected and
the system is routing you to a destination), the vo-
lume of the navigation guidance voice will be the
same as the volume of the music files being
played, even if a different volume level has been
selected on
“
Master
”
or
“
Voice
”
or
“
Dynamic Vo-
lume
”
in the
“
Sound settings
”
menu.
Setting the rear output
The navigation system
’
s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch
Rear SP
to
Sub W
,
you can connect a rear speaker lead directly to
a subwoofer without using an auxiliary amp.
Initially, the navigation system is set for a rear
full-range speaker connection (
Full
).
1
Touch [Rear SP] on the
“
AV System Set-
tings
”
menu.
=
For details, refer to
Displaying the
“
AV Sys-
tem Settings
”
menu
on page 164.
2
Touch [Rear SP] to switch the rear out-
put setting.
When no subwoofer is connected to the rear
output, select
Full
.
When a subwoofer is connected to the rear
output, select
Sub W
.
p
Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
Acquiring/Cataloging iPod
music information
If you always set the language other than
“
Eng-
lish
”
on
“
Program language:
”
, this setting is
unnecessary.
Unless [
VR Catalog Mode
] is turned off, this
navigation system tries to acquire the informa-
tion needed to operate iPod with voice com-
mands. It may take a short period of time to
transfer the information. Change the setting
according to your usage.
The navigation system starts acquiring/catalo-
ging music information (1) when the iPod is
connected or when the system boots up while
the iPod is connected and (2) when iPod is the
selected and displayed AV Source, unless [
VR
Catalog Mode
] is turned off.
p
If you do not use iPod, this setting is un-
necessary.
p
During transfer, iPod operations (such as
[
Shuffle
], [
Menu
], or [
Video
]) are not
available.
p
Once the cataloging is completed, you can
deactivate [
VR Catalog Mode
] until you
update the content/data on iPod. If you up-
date the iPod data, activate [
VR Catalog
Mode
] again to transfer the music informa-
tion and synchronize the music information
for voice commands with the data on iPod.
p
After you select
“
Off
”
in [
VR Catalog
Mode
], the system doesn
’
t catalog the
data on the iPod. In such case, the pre-
viously cataloged data are available as
voice commands.
Customizing preferences
En
166
Chapter
25