background image

Note:

• The position of the parking brake switch depends

on the vehicle model. For details, consult the
vehicle Owner’s Manual or dealer.

Connection method

Clamp the lead.

1.

2. Clamp firmly with

needle-nosed
pliers.

WARNING

Parking brake
switch

Power supply side

Ground side

Light green
Used to detect the ON/OFF status of the parking brake.
This lead must be connected to the power supply side of the parking
brake switch.

Yellow
To terminal always supplied
with power regardless of
ignition switch position.

Fuse holder

Fuse resistor

Red
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.

Black (ground)
To vehicle (metal) body.

Orange/white
To lighting switch terminal.

Fuse resistor

This product

Violet/white
See the section “When connecting
with a rear view camera”

Rear video output
(REAR VIDEO OUTPUT)

Rear audio output
(REAR AUDIO OUTPUT)

Audio output
(AUDIO OUTPUT)

15 cm
(5-7/8 in.)

LIGHT GREEN LEAD AT POWER CONNECTOR IS DESIGNED TO
DETECT PARKED STATUS AND MUST BE CONNECTED TO THE
POWER SUPPLY SIDE OF THE PARKING BRAKE SWITCH. IMPROPER
CONNECTION OR USE OF THIS LEAD MAY VIOLATE APPLICABLE
LAW AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.

Fig. 2

Connecting the Units

<ENGLISH>

Connecting the Units

<ENGLISH>

When connecting with a Pioneer head unit

Multi-CD player
(sold separately)

IP-BUS cable

15 cm
(5-7/8 in.)

IP-BUS input (Blue)

Hide-away TV tuner
(e.g. GEX-P6400TV)
(sold separately)

AV-BUS input (Blue)

Navigation unit
(e.g. AVIC-88DVD)
(sold separately)

26 pin cable

Yellow

AV-BUS cable (supplied
with TV tuner)

IP-BUS cable (supplied
with TV tuner)

40 cm
(1 ft. 4 in.)

Black

Blue

Black

Blue

Blue

This product

Head unit
(sold separately)

Guide speaker output
(GUIDE SP OUTPUT)

Guide speaker
(e.g. CD-TS37GP)
(sold separately)

Blue

Wired remote control output
(WIRED REMOTE OUTPUT)

15 cm
(5-7/8 in.)

If you use this unit with a navigation
unit (e.g. AVIC-88DVD), be sure to
connect a guide speaker to this unit’s
guide speaker output terminal.

Remote control cable
(supplied)

40 cm
(1 ft. 4 in.)

If you use this unit with a head
unit features digital input (e.g.
DEX-P9), this terminal must
be connected to the head unit’s
digital input terminal.

To jack for the wired remote control

To IP-BUS input (Blue)

Yellow/black

Fig. 3

When connecting with a car stereo with RCA audio input

Multi-CD player
(sold separately)

IP-BUS cable

15 cm
(5-7/8 in.)

IP-BUS input (Blue)

Hide-away TV tuner
(e.g. GEX-P6400TV)
(sold separately)

AV-BUS input (Blue)

Navigation unit
(e.g. AVIC-88DVD)
(sold separately)

26 pin cable

Yellow

AV-BUS cable (supplied
with TV tuner)

IP-BUS cable (supplied
with TV tuner)

40 cm
(1 ft. 4 in.)

Black

Blue

Black

Blue

Blue

This product

Car stereo with
RCA input

Guide speaker output
(GUIDE SP OUTPUT)

Guide speaker
(e.g. CD-TS37GP)
(sold separately)

15 cm
(5-7/8 in.)

If you use this unit with a navigation
unit (e.g. AVIC-88DVD), be sure to
connect a guide speaker to this unit’s
guide speaker output terminal.

Audio output
(AUDIO OUTPUT)

15 cm
(5-7/8 in.)

RCA cable
(sold separately)

When connecting with a car
stereo with FM reception
capability, use a FM modulator
(e.g. CD-V61FM).

Fig. 4

Connecting the power cord

Fig. 3

Summary of Contents for AVX-P8DVD









Reviews: