42
TS5, BCT-1510, BCT-1520,
BCT-1530
•
Pin Function (1/5)
Signal names are prefixed by
not
if they are active low; otherwise they are active high.
Pin
Number
Function
VDD
13
Power supply
GND
16
Ground
VClamp1-3
1
1. The VClamp pins are a power supply bus used to diode clamp the voltage on 5V tolerant digital input or output pins to.
The voltage on the digital signal pin is then clamped to within VImax (5.5V) if the applied voltage is increased above 5V.
If the device is to be interfaced to 3.3V logic signals only, then the VClamp pins can be connected to the STi5512 3.3V VDD
power supply. However if any pin is to be interfaced to a 5V logic signal, then the VClamp pins must be connected to the 5V
power supply (the 5V logic device power supply). Note in this case the 5V power supply must be capable of sinking the clamp
current of transient signals above 5V.
In the latter case it is important to ensure the correct power supply ramp sequence. The VClamp power supply must be ap-
plied before or at the same time as the VDD 3.3V power supply. This is to ensure that during power supply power up and
power down, VClamp > VDD + 0.5V.
3
Power supply for clamp diodes
VDDA0-1
2
Analog power supply for PAL/NTSC/SECAM encoder
VSSA0-1
2
Analog ground for PAL/NTSC/SECAM encoder
RTCVDD
1
Real time clock supply
VDD_VPLL
1
Analog power supply for video PLL
VSS_VPLL
1
Analog ground for video PLL
Table 1 Power supply pins
Pin
In/Out
Function
R_OUT
1
out
Red output
G_OUT
1
out
Green output
B_OUT2
1
out
Blue output
C_OUT
1
out
Chroma output
CV_OUT
1
out
Composite video output
Y_OUT
1
out
Luma output
I_REF_DAC_RGB
1
in
DAC current reference
I_REF_DAC_YCC
1
in
DAC current reference
V_REF_DAC_RGB
1
in
DAC voltage reference
V_REF_DAC_YCC
1
in
DAC voltage reference
OSD_ENABLE
in/out
OSD enable
notHSYNC
in/out
Horizontal sync
ODD_OR_EVEN
in/out
Vertical sync
YC0-7
2
output
Digital YUV output
CFC
input
DENC color burst phase and frequency control.
This pin can be used in non-scart based Genlock applications.
If it is not used, this pin must ground.
Table 2 Video output interface pins
Summary of Contents for BCT-1510
