background image

What’s in the box?

Setup: In Vehicle

inno

 car kit

CD-INCAR1

Peel off adhesive liner

Either orientation may be used.

Warning:  Failure to properly install the antenna may result in injury to
yourself or to others if it becomes detached during an accident. 

option 1

option 2

option 3

Listen to Live XM* and recorded XM* content

Play MP3 and WMA files

Listen in your car or home

Manage your tracks, favorite 
channels, and playlists 

*Hardware and required monthly subscription sold separately. Installation cost and other fees and taxes, including a 
one-time activation fee may apply. Subscription fee is consumer only. XM products, programming, services, and fees are 
subject to change, at any time, without notice. Channels with frequent explicit language are indicated with an XL. Channel 
blocking is available for XM radio receivers by calling 1-800-XM-RADIO. Subscriptions subject to Customer Agreement 
available at xmradio.com. XM service only available in the 48 contiguous United States. ©2006 XM Satellite Radio Inc. 
All rights reserved.

inno

 car kit 

Mount the antenna to the roof 
or trunk of the vehicle. During 
installation, make sure you are 
outdoors and not obstructed by 
tall buildings.

How to install the antenna

Every vehicle is different; for your safety, follow all instructions carefully. Consult a 
professional installer if you have questions.

How to use the swivel mount

Choose the best way to mount your car dock.

To install the swivel mount, first find a suitable location. The swivel mount’s adhesive 
is very strong and may be difficult to remove. Do not install this mount on leather 
surfaces and make sure the air temperature is at least 60ºF.

1. Clean the mounting surface with the 
  surface preparation kit. Peel away the 
 adhesive 

liner.

2. Firmly press the swivel mount to the surface for 30 seconds. Allow 24 hours 
  before using the mount.

If you need to remove the mount, carefully lift the adhesive pad with your fingers or a 
spoon. Warming with a hair dryer for several minutes will help soften the adhesive.

How to use the vent m

Setup: In Vehicle

To install the vent mount, f
inno and its car dock.

To remove the vent moun
it into the vent and lift upw
slightly to release the mou
from the vent vane.

1. To insert the vent mount,  
  push it into the vent as sho

How to receive XM through your car stereo

Plug in all of the connectors once you 
have mounted the radio, installed the 
antenna and plugged in the power 
adapter. The line out may be used for 
an optional cassette adapter or direct 
adapter if FM reception is not good in 
your area.

antenna 

power

line out

1.  Insert inno into the car dock

2.  Turn your inno player on

3.  Turn on your car stereo. Look for a 
 

channel that sounds like it is receiving a

 

weak or no station. (88.1 - 107.9)

4.  On your inno player press the XM button. 
 

Scroll down to “Settings” choose “FM 

 

Modulator” then pick “FM Frequency.” 

 

You may be in either “Live XM” or “My 

 

Music” modes. (You will not hear any 

 

music in the “My Music” mode unless you 

 

have recorded content or mp3s)

5. Follow the on screen instructions to choose the same frequency as you chose 
  on your car stereo. you should now be able to hear XM through your car stereo.

Protect your ears

-  Take care so that the earb
 walking or exercising.
-  Do not turn up the volume
 high volume.
-  Stop using your inno or tur

Sound can be deceiving. Ove
of sound. So what sounds “
your equipment at a safe lev

To establish a safer lev

the sound until you can hea

Once you have establi

it there; taking a minute to d
Pioneer and the Consumer E
to excessive noise. Under co
85 decibels can be dangerou
or loud shouting at 3 feet aw
3 feet away are around 90 d
the greater the danger of pe
hearing loss, bodily injury or

On all complaints and conce

For hook-up and operation of your u

PIONEER ELECTRONICS SERV
P.O. BOX 1760, LONG BEACH
1-800-421-1404
www.pioneerelectronics.com

remote

car antenna

car dock

power adapter

cassette
adapter

mounts

cleaning kit

You can adjust the tension of 
the mount with a screwdriver.  
Be careful not to loosen it too 
much when you are adjusting it, 
or the swivel may come apart.

enginno_instlgd_fin.ai   4/14/06   1:18:27 PM

Summary of Contents for CD-INCAR1

















Reviews: