Setup: In Vehicle
Peel off adhesive liner
Either orientation may be used.
esult in injury to
accident.
tion 3
fees and taxes, including a
amming, services, and fees are
are indicated with an XL. Channel
ect to Customer Agreement
2006 XM Satellite Radio Inc.
s carefully. Consult a
How to use the swivel mount
Choose the best way to mount your car dock.
To install the swivel mount, first find a suitable location. The swivel mount’s adhesive
is very strong and may be difficult to remove. Do not install this mount on leather
surfaces and make sure the air temperature is at least 60ºF.
1. Clean the mounting surface with the
surface preparation kit. Peel away the
adhesive
liner.
2. Firmly press the swivel mount to the surface for 30 seconds. Allow 24 hours
before using the mount.
If you need to remove the mount, carefully lift the adhesive pad with your fingers or a
spoon. Warming with a hair dryer for several minutes will help soften the adhesive.
How to use the vent mount
Setup: In Vehicle
To install the vent mount, find a horizontal vent that is strong enough to hold your
inno and its car dock.
To remove the vent mount, push
it into the vent and lift upwards
slightly to release the mount’s hooks
from the vent vane.
1. To insert the vent mount,
push it into the vent as shown.
or
2. Attach the car dock to either
mount by sliding it into place.
Installed vent mount
How to receive XM through your car stereo
Plug in all of the connectors once you
have mounted the radio, installed the
antenna and plugged in the power
adapter. The line out may be used for
an optional cassette adapter or direct
adapter if FM reception is not good in
your area.
antenna
power
line out
1. Insert inno into the car dock
2. Turn your inno player on
3. Turn on your car stereo. Look for a
channel that sounds like it is receiving a
weak or no station. (88.1 - 107.9)
4. On your inno player press the XM button.
Scroll down to “Settings” choose “FM
Modulator” then pick “FM Frequency.”
You may be in either “Live XM” or “My
Music” modes. (You will not hear any
music in the “My Music” mode unless you
have recorded content or mp3s)
5. Follow the on screen instructions to choose the same frequency as you chose
on your car stereo. you should now be able to hear XM through your car stereo.
Protect your ears
- Take care so that the earbud cable is not caught by your arm or other objects while
walking or exercising.
- Do not turn up the volume too high. Doctors warn against prolonged exposure to
high volume.
- Stop using your inno or turn the volume down if you have ringing in your ears.
Sound can be deceiving. Over time your hearing “comfort level” adapts to higher volumes
of sound. So what sounds “normal” can actually be loud and harmful to your hearing. Set
your equipment at a safe level BEFORE your hearing adapts.
To establish a safer level:
Start your volume control at a low setting; Slowly increase
the sound until you can hear it comfortably and clearly, without distortion.
Once you have established a comfortable sound level:
Set the dial and leave
it there; taking a minute to do this now will help to preserve hearing.
Pioneer and the Consumer Electronics Association recommend you avoid prolonged exposure
to excessive noise. Under constant exposure such as sustained listening, sound levels above
85 decibels can be dangerous without hearing protection. (For reference, a garbage disposal
or loud shouting at 3 feet away are around 80 decibels; a food blender or gas lawn mower at
3 feet away are around 90 decibels.) The longer your exposure and/or higher the sound level,
the greater the danger of permanent hearing damage. Pioneer disclaims all liability for
hearing loss, bodily injury or property damage as a result of use or misuse of this product.
On all complaints and concerns call Customer Support at 1- 800-421-1404
For hook-up and operation of your unit or to locate an Authorized Service Company, please call or write:
PIONEER ELECTRONICS SERVICE, INC.
P.O. BOX 1760, LONG BEACH, CALIFORNIA 90810
1-800-421-1404
www.pioneerelectronics.com
mounts
cleaning kit
You can adjust the tension of
the mount with a screwdriver.
Be careful not to loosen it too
much when you are adjusting it,
or the swivel may come apart.
enginno_instlgd_fin.ai 4/14/06 1:21:33 PM
