Pioneer CP-VSL3, Installation And Usage Instructions

8

En

6

Fasten the mounting fixture to the wall

When fastening the fixture to the wall, use a minimum of
six screw locations, including the four holes at the top and
bottom of the fixture (

✱

 marks). Mounting screws are not

furnished. Depending on the construction of the wall,
drywall anchors*

1

 or other reinforcements may be

necessary; be sure to provide fully sufficient*

2

 support for

the speaker.

*

1

Anchors should have minimum strength of
0.3kN (Newtons).

*

2

A safety factor of x4 or more should be
provided.

7

Install bushings

Install two bushings per speaker. The bushing is installed
so that the bushing's flange is separated slightly from the
fixture's surface; this helps prevent the speaker from
falling suddenly in the event the fixture should
accidentally become detached from the wall. Use drywall
anchors or other means to provide ample strength.

8

Attach safety strap to wall

Attach the safety strap to the wall. Using anchor bolts or
other means as necessary, provide ample support strength.
The strap is an important safety device to prevent the
speaker from falling, and should be installed in all cases.

9

Connect speaker cords and pass through
mounting fixture

Connect the speaker cords and pass them through the
square hole on the bottom of the mounting fixture.
If you wish to pass speaker cords through the rear of the
mounting fixture, use either of the two holes on the bottom
of the fixture, then pass the cord through any of the three
round holes (

φ

 30) on the rear surface of the fixture, as

shown.

• When threading speaker cords from rear of speaker

10

Insert upper plate into mounting fixture

While passing the speaker’s terminals through the square
hole in the fixture’s bottom, set the speaker onto the
fixture, then place the upper plate onto the top of the
speaker as you insert the upper plate’s tab into the
opening on the top of the fixture.

Safety strap

NOTE

<Cross section>

Bushing

Wall

Screw

Mounting
fixture

Bushing

When accessing
speaker cords the
rear of the speakers,
use one of the three
round holes (

φ

 30) in

the rear surface of
the mounting fixture.

Use either of these

Opening