Controls and displays
04
23
En
English
8
Receiver setting buttons
Set the remote control operation selector
switch to
RECEIVER
first to access:
AUDIO PARAMETER
– Use to access the
Audio options.
VIDEO PARAMETER
– Use to access the
Video options.
HOME MENU
– Use to access the Home
Menu.
RETURN
– Press to confirm and exit the
current menu screen.
9
///
/ENTER
Use the arrow buttons when setting up your
surround sound system and the Audio or Video
options.
10 Receiver Control buttons
Set the remote control operation selector
switch to
RECEIVER
first to access:
STATUS
– Press to check selected receiver
settings.
PHASE CTRL
– Press to switch on/off
Phase Control or Full Band Phase Control.
CH LEVEL
– Press repeatedly to select a
channel, then use
/
to adjust the level.
THX
– Press to select a Home THX
listening mode.
PQLS
– Press to select the PQLS setting.
AUTO/ALC/DIRECT
– Switches between
Auto Surround, Auto Level Control,
Optimum Surround mode and Stream
Direct mode.
STEREO
– Switches between stereo
playback and Front Stage Surround
Advance modes.
STANDARD
– Press for Standard decoding
and to switch various modes (
2
Pro Logic,
Neo:6, etc.).
ADV SURR
– Use to switch between the
various surround modes.
SIGNAL SEL
– Use to select an input
signal.
SLEEP
– Use to put the receiver in sleep
mode and select the amount of time
before sleep.
DIMMER
– Dims or brightens the display.
A.ATT
– Attenuates (lowers) the level of an
analog input signal to prevent distortion.
SBch
– The
SBch
button can only be used
on models to which it applies.
MCACC
– Press to switch between MCACC
presets.
HDMI OUT
– Switch the HDMI output
terminal.
11
LIGHT
Press to turn on/off the illumination for the
buttons.
1
12 Remote control operation selector switch
Set to
RECEIVER
to operate the receiver,
TV
or
SOURCE
to operate the TV or the source
device.
When this switch is set to
RECEIVER
, the
receiver can be controlled (used to select the
white commands). Also use this switch to set
up surround sound.
13 VOL +/–
Use to set the listening volume.
14 MUTE
Mutes the sound or restores the sound if it has
been muted (adjusting the volume also
restores the sound).
Note
1 Press and hold in the
LIGHT
button for 5 seconds to change the illumination mode 1 or 2. When set to
LIGHT MODE
2
(default), the illumination only lights when the remote control
LIGHT
button is pressed. When switched to
LIGHT
MODE 1
, the illumination lights whenever buttons are operated. Setting
LIGHT MODE 1
will shorten the service life
of the batteries.
CU-RF100.book Page 23 Wednesday, March 17, 2010 6:13 PM
