15
CX-683
3. DISASSEMBLY
-
Removing the PU Unit
1. Provide short solder in section A, then remove the
connector.
2. Remove the two screws, then erect the board in the
direction indicated by the white arrow head.
3. Remove the two screws and two springs.
4. Drive out the PU Unit through the direction indicated
by the white arrow head.
-
Carriage Motor and Spindle Motor
Removing the Loading Motor (1/2)
1. Provide short solder in section A, then remove the
connector.
2. Peel off solder in section B, then remove the lead
wire.
3. Remove the two screws, then dismount the MD Unit.
4. Remove the connector situated in section C.
Note: Before removing the Loading Motor, insert the
finished MD Unit, then clamp it.
