3 Press
a
or
b
to adjust the output level
of the subwoofer.
Each press of
a
or
b
increases or decreases
the level of the subwoofer.
+6
6
is displayed
as the level is increased or decreased.
Usingnon fadingoutput
When the non fading output setting is on, the
audio signal does not pass through this unit
s
low pass filter (for the subwoofer), but is out-
put through the RCA output.
1 Press AUDIO to select non fading out-
put on/off setting.
Press
AUDIO
until
NOFAD:ON
appears in the
display.
#
When the subwoofer controller setting is only
P/O :FUL
, you can switch to the non fading out-
put on/off setting. (Refer to page 46.)
2 Press
a
to turn non fading output on.
NOFAD:ON
appears in the display. Non fading
output is now on.
#
To turn non fading output off, press
b
.
Adjustingnon fadingoutput level
When the non fading output is on, you can ad-
just the level of non fading output.
1 Press AUDIO to select non fading out-
put setting.
Press
AUDIO
until
NOFAD: 0
appears in the
display.
2 Press
a
or
b
to adjust the output level
of the non fading.
Each press of
a
or
b
increases or decreases
the level of the non fading.
+6
6
is displayed
as the level is increased or decreased.
Usingthe high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn the HPF
(high pass filter) on. Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
1 Press AUDIO to select HPF.
Press
AUDIO
until
HPF
appears in the display.
2 Press
a
to turn high pass filter on.
HPF : 80
appears in the display. High pass fil-
ter is now on.
#
If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of
HPF : 80
.
#
To turn high pass filter off, press
b
.
3 Press
c
or
d
to select cut-off frequency.
Each press of
c
or
d
selects cut-off frequen-
cies in the following order:
50
80
125
(Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Note
If you switch the SFEQ setting, the HPF function
is automatically turned off. By turning the HPF
function on after selecting the SFEQ setting, you
can combine HPF function with SFEQ
function.
Adjustingsource levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
!
Settings are based on the FM tuner volume
level, which remains unchanged.
Audio Adjustments
En
43
English
Section
09
