2 Press
a
or
b
to turn WARN on or off.
Pressing
a
or
b
will turn
WARN
on or off and
that status will be displayed (e.g.,
WARN :ON
).
Switchingthe auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press FUNCTION to select AUX.
Press
FUNCTION
repeatedly until
AUX
ap-
pears in the display.
2 Press
a
or
b
to turn AUX on or off.
Pressing
a
or
b
will turn
AUX
on or off and
that status will be displayed (e.g.,
AUX :ON
).
Switchingthe dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car
s headlights are turned on. You
can turn dimmer on or off.
1 Press FUNCTION to select DIMMR.
Press
FUNCTION
repeatedly until
DIMMR
ap-
pears in the display.
2 Press
a
or
b
to turn DIMMR on or off.
Pressing
a
or
b
will turn
DIMMR
on or off
and that status will be displayed (e.g.,
DIMMR :ON
).
Settingthe rear output and
subwoofer controller
This unit
s rear output (rear speaker leads out-
put) can be used for full-range speaker
(
R-SP :FUL
) or subwoofer (
R-SP :S/W
) connec-
tion. If you switch the rear output setting to
the
R-SP :S/W
, you can connect a rear speaker
lead directly to a subwoofer without using an
auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
R-SP :FUL
). When rear output
are connected to full range speakers (when
R-SP :FUL
is selected), you can connect the
RCA subwoofer output to a subwoofer. In this
case, you can select whether to use the sub-
woofer controller
s (low pass filter, phase)
built-in
P/O :S/W
or the auxiliary
P/O :FUL
.
1 Press FUNCTION to select R-SP.
Press
FUNCTION
repeatedly until
R-SP
ap-
pears in the display.
2 Press
a
or
b
to switch the rear output
setting.
Pressing
a
or
b
will switch between
R-SP :FUL
(full-range speaker) and
R-SP :S/W
(subwoofer) and that status will be displayed.
#
When no subwoofer is connected to the rear
output, select
R-SP :FUL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
R-SP :S/W
.
#
When the rear output setting is
R-SP :S/W
,
you cannot change the subwoofer controller.
3 Press
c
or
d
to switch the subwoofer
output or non fading output.
Pressing
c
or
d
will switch between
P/O :S/W
and
P/O :FUL
and that status will be displayed.
Notes
!
Even if you change this setting, there is no
output unless you turn the non fading output
(refer to
Using non fading output
on page 43)
Initial Settings
En
46
Section
10
