Black plate (23,1)
2
Push MULTI-CONTROL up or down to
select a desired level.
0
to
+6
is displayed as the level is increased or
decreased.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1
Use MULTI-CONTROL to select HPF.
2
Press MULTI-CONTROL to turn high
pass filter on.
80Hz
appears in the display. High pass filter is
now on.
#
If the high pass filter has been previously ad-
justed, the frequency of that previously selected
will be displayed instead of
80Hz
.
#
To turn high pass filter off, press
MULTI-CONTROL
again.
3
Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time
MULTI-CONTROL
is pushed left or
right, cut-off frequencies are selected in the
following order:
50Hz
—
63Hz
—
80Hz
—
100Hz
—
125Hz
Only frequencies higher than those in the se-
lected range are outputted from the front or
rear speakers.
Adjusting source levels
SLA (source level adjustment) lets you adjust
the volume level of each source to prevent ra-
dical changes in volume when switching be-
tween sources.
!
Settings are based on the FM tuner volume
level, which remains unchanged.
1
Compare the FM tuner volume level
with the level of the source you wish to ad-
just.
2
Use MULTI-CONTROL to select SLA.
3
Push MULTI-CONTROL up or down to
adjust the source volume.
Each time
MULTI-CONTROL
is pushed up or
down, source volume increases or decreases.
SLA +4
to
SLA
–
4
is displayed as the source
volume is increased or decreased.
Notes
!
The AM tuner volume level can also be ad-
justed with source level adjustments.
!
The built-in CD player and the multi-CD player
are set to the same source level adjustment
volume automatically.
!
External unit 1 and external unit 2 are set to
the same source level adjustment volume
automatically.
<XRD7144-A/N>23
Operating this unit
En
23
English
Section
02
