Black plate (26,1)
Setting the rear output and
subwoofer controller
This unit
’
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :F.Range
) or subwoo-
fer (
Rear SP :S/W
) connection. If you switch
the rear output setting to
Rear SP :S/W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :F.Range
).
1
Use MULTI-CONTROL to select
S/W control.
2
Press MULTI-CONTROL to switch the
rear output setting.
Pressing
MULTI-CONTROL
will switch be-
tween
Rear SP :F.Range
(full-range speaker)
and
Rear SP :S/W
(subwoofer) and that status
will be displayed.
#
When no subwoofer is connected to the rear
output, select
Rear SP :F.Range
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
Rear SP :S/W
.
Notes
!
Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer to
Using subwoofer output
on page
22).
!
If you change this setting, subwoofer output
in the audio menu return to the factory set-
tings.
!
Both rear speaker leads outputs and RCA rear
output are switched simultaneously in this
setting.
Switching the sound muting/
attenuation
Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
!
The sound is muted or attenuated,
MUTE
or
ATT
are displayed and no audio adjust-
ment is possible.
!
Sound from this system returns to normal
when the muting or attenuation is can-
celed.
1
Use MULTI-CONTROL to select Mute.
2
Press MULTI-CONTROL to switch the tel-
ephone muting/attenuation.
Pressing
MULTI-CONTROL
will switch be-
tween
TEL ATT
(attenuation) and
TEL mute
(muting) and that status will be displayed.
Switching the feature demo
The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON.
1
Use MULTI-CONTROL to select
Demonstration.
2
Press MULTI-CONTROL to turn the fea-
ture demo on.
#
To turn the feature demo off, press
MULTI-CONTROL
again.
Notes
!
Remember that if the feature demo continues
operating when the car engine is turned off, it
may drain battery power.
!
You can also turn on or off feature demo by
pressing
DISPLAY
while this unit is turned off.
For more details, see
Feature demo mode
on
page 6.
Switching the reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds.
1
Use MULTI-CONTROL to select
Reverse mode.
<XRD7144-A/N>26
Operating this unit
En
26
Section
02
