9
En
En
g
lis
h
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*3 Not available when [OFF] is selected in [SUB.W].
BALANCE
Adjust the left and right speaker balance.
EQ SETTING
[SUPER BASS], [POWERFUL],
[TODOROKI], [VOCAL],
[CUSTOM1], [CUSTOM2], [FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band:
[80HZ], [250HZ],
[800HZ], [2.5KHZ], [8KHZ]
Equalizer level:
[+6] to [–6]
Select or customize the equalizer curve.
[CUSTOM1] can be set separately for each source.
However, each of the below combinations are set
to the same setting automatically.
[CUSTOM2] is a shared setting used for all
sources.
You can also switch the equalizer by pressing
repeatedly.
LOUDNESS
[OFF], [LOW], [MID], [HI]
Compensate for clear sound at low volume.
SUB.W
*2
[NOR], [REV], [OFF]
Select the subwoofer phase.
SUB.W CTRL
*2*3
Cut-off frequency:
[50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level:
[–24] to [+6]
Slope level:
[–12], [–24]
Only frequencies lower than those in the
selected range are output from the subwoofer.
BASS BOOST
[0] to [+6]
Select the bass boost level.
HPF SETTING
Cut-off frequency:
[OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level:
[–12], [–24]
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
SLA
[+4] to [–4]
Adjust the volume level for each source except
FM.
Menu Item
Description
You can also access to these menus when the unit is turned off.
*1 Depending on your car, this function may not work properly. In this case, contact your dealer or an
authorized PIONEER Service Station.
*2 Please use a commercially available wiring harness for each car model when [PRESET] mode is
engaged, and use a commercially available adapter when in [PIONEER].
SYSTEM settings
Menu Item
Description
CLOCK SET
Set the clock (page 4).
12H/24H
[12H], [24H]
Select the time notation.
AUTO PI
[ON], [OFF]
Search for a different station with the same
programming, even if using a preset station.
AUX
[ON], [OFF]
Set to [ON] when using an auxiliary device
connected to the unit.
ANDROID WIRED
[MEMORY], [APP CONTROL]
Select the appropriate connection method for an
Android device.
P.APP AUTO ON
[ON], [OFF]
Select [ON] to automatically launch Pioneer ARC
APP when an Android device is connected to the
unit via AOA. (Not available when [MEMORY] is
selected in [ANDROID WIRED].)
S.REMOTE
*1*2
[OFF], [PIONEER], [PRESET]
Select [PIONEER] or [PRESET] according to your
wired remote control.
USB AUTO
[ON], [OFF]
Select [ON] to automatically switch to [USB]
source when a USB device is connected to the
unit.
Select [OFF] when a USB device is being
connected to the unit just for charging.
