11
En
En
g
lis
h
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*3 Not available when [OFF] is selected in [SUB.W].
EQ SETTING
[SUPER BASS], [POWERFUL],
[NATURAL], [VOCAL], [CUSTOM1],
[CUSTOM2], [FLAT]
Select an equalizer band and
level for further customizing.
Equalizer band:
[80HZ], [250HZ],
[800HZ], [2.5KHZ], [8KHZ]
Equalizer level:
[+6] to [–6]
Select or customize the equalizer curve.
[CUSTOM1] can be set separately for each source.
However, each of the below combinations are set
to the same setting automatically.
•
USB, iPod, PANDORA (iPhone), ANDROID, and
APP (iPhone)
[CUSTOM2] is a shared setting used for all
sources.
LOUDNESS
[OFF], [LOW], [MID], [HI]
Compensate for clear sound at low volume.
SUB.W
*2
[NOR], [REV], [OFF]
Select the subwoofer phase.
SUB.W CTRL
*2*3
Cut-off frequency:
[50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level:
[–24] to [+6]
Slope level:
[–12], [–24]
Only frequencies lower than those in the
selected range are output from the subwoofer.
BASS BOOST
[0] to [+6]
Select the bass boost level.
HPF SETTING
Cut-off frequency:
[OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level:
[–12], [–24]
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
SLA
[+4] to [–4]
Adjust the volume level for each source except
FM.
Each of the below combinations are set to the
same setting automatically.
•
USB, iPod, PANDORA (iPhone), ANDROID, and
APP (iPhone)
Menu Item
Description
You can also access to these menus when the unit is turned off.
SYSTEM settings
Menu Item
Description
CLOCK SET
Set the clock (page 5).
12H/24H
[12H], [24H]
Select the time notation.
INFO DISPLAY
(Only for DEH-X3800UI/X3810UI)
Display the item on the sub information display.
Select from “SPEANA”, “LEVEL METER”, “SOURCE”,
“CLOCK”, and “OFF”.
AUX
[ON], [OFF]
Set to [ON] when using an auxiliary device
connected to the unit.
USB AUTO
[ON], [OFF]
Select [ON] to automatically switch to [USB]
source when a USB device/iPod is connected to
the unit.
Select [OFF] when a USB device/iPod is being
connected to the unit just for charging.
ANDROID WIRED
[MEMORY], [APP CONTROL]
Select the appropriate connection method for an
Android device.
P.APP AUTO ON
[ON], [OFF]
Select [ON] to automatically launch the car remote
application when an Android device is connected
to the unit via AOA. (Not available when
[MEMORY] is selected in [ANDROID WIRED].)
