27
DJM-2000
5
6
7
8
5
6
7
8
A
B
C
D
E
F
5.4 CONNECTION CHECK WITH EACH INTERFACE
[1. USB B connector]
Whether communication between the PC connected via the USB B connector and this unit is properly performed or not can
be confirmed on the PC.
Note:
Installation of the driver software is necessary.
Use Device Manager for checking.
If the PC and this unit are properly connected, the components of this unit are added in Device Manager (under Hardware)
as
devices.
If all components are properly displayed, the PC and this unit are properly communicating via the USB connector.
In a case of Windows XP:
Start, Control Panel, System, Hardware, then Device Manager
Devices to be added:
• Universal Serial Bus controllers
USB
Composite
Device
• Under “Sound, video and game controllers”
PIO
N
EER DJM-2000
USB
Audio
Device
A communication check may be easily performed if connection is
made with Device Manager displayed on the PC screen.
[2. LINK]
You can check from this unit if the mixer can properly communicate via LA
N
.
Note:
Use a Category 5 cable or a cable with higher specifications for connection.
Either a straight or cross LA
N
cable can be used when the unit is directly connected with the PC, but when the unit is
connected with the PC via a hub, be sure to use a straight cable.
Check the LAN conditions, using Test mode of this unit:
1
Start up the unit in Test mode.
2
Open Page01: Device Test.
3
The IP Address and Subnet Mask are indicated at the bottom of the screen.
4
Check if the LA
N
is properly connected.
When the LAN is properly connected:
IP Address : xxx.xxx.xxx.xxx
Subnet Mask : yyy.yyy.yyy.yyy
x and y: Any numeric value
Four blocks of numerical string delimited by dots
When the LAN is not properly connected:
IP Address : can not get IP addr
Subnet Mask :
USB
LAN
Summary of Contents for DJM-2000
