09
47
En
HDMI troubleshooting
(DV-410V only)
Can’t hear effect of Virtual
Surround.
• The Virtual Surround effect is only output through the
AUDIO OUT L/R
analog audio outputs.
• The effectiveness of Virtual Surround varies with the disc.
Problem
Remedy
Problem
Remedy
No HDMI audio output.
• Check whether or not
HDMI Out
is set to
Off
(page 35).
• This unit has been designed to be compliant with HDMI
(High-Definition Multimedia Interface). Depending on the
component you have connected, unreliable signal transfers may
result.
• If the front panel HDMI indicator is lit:
– You won’t hear any sound from the HDMI output if the source
component is only DVI/HDCP-compatible.
• If the front panel HDMI indicator is unlit then:
– Make sure that you’ve selected this player as the HDMI input in
the settings for the component you’re using. You may need to refer
to the instruction manual of the component to do this.
– Check that the HDMI cable is connected properly and that the
cable isn’t damaged.
– Check that components connected using the HDMI interface are
switched on and HDMI compatible.
No HDMI video output.
• Make sure that you’ve selected this player as the HDMI input in
the settings for the component you’re using. You may need to refer
to the instruction manual of the component to do this.
• Check that the HDMI cable is connected properly and that the
cable isn’t damaged.
• Check that components connected using the HDMI interface are
switched on and HDMI compatible.
• This unit has been designed to be compliant with HDMI
(High-Definition Multimedia Interface). Depending on the
component you have connected, using a DVI connection may result
in unreliable signal transfers.
• Make sure the resolution on this player matches that of the
component you have connected using HDMI. See
HDMI
Resolution
on page 37 to change the HDMI resolution. See
Resetting the output resolution to the default setting with HDMI
connection
on page 14 if you want to reset the output resolution.
No multichannel HDMI
audio.
• Make sure the
HDMI Out
setting is set to
Auto
(page 35). See
also
About the HDMI audio output settings
on page 41.
Component Out cannot be
set to Interlace.
• You can use the
Interlace
setting if the
HDMI Resolution
is set to
720x480i (NTSC)/720x576i (PAL)
(page 37).
A connected DVI component
(with HDCP) doesn’t work
with this player.
• This unit has been designed to be compliant with HDMI
(High-Definition Multimedia Interface). Depending on the
component you have connected, using a DVI connection may result
in unreliable signal transfers.
DV510K_IBD_EN.book 47 ページ 2008年3月28日 金曜日 午前11時54分