Connections
02
11
En
English
Chapter 2
Connections
Easy connections
Important
• Before making or changing any connections, switch off the power and disconnect the power
cable from the AC outlet.
• The setup described here is a basic setup that allows you to play discs using just the cables
supplied with the player. In this setup, stereo audio is played through the speakers in your TV.
• This player is equipped with copy protection technology. Do not connect this player to your
TV via a VCR using audio/video or S-video cables, as the picture from this player will not
appear properly on your TV. (This player may also not be compatible with some combination
TV/VCRs for the same reason; refer to the manufacturer for more
information.)
1
Connect the VIDEO OUT and AUDIO
OUT (5.1ch)/AUDIO OUT L/R jacks to a set
of A/V inputs on your TV.
Use the supplied audio/video cable,
connecting the red and white plugs to the
audio outputs and the yellow plug to the video
output. Make sure you match up the left and
right audio outputs with their corresponding
inputs for correct stereo sound.
See below if you want to use a component or
S-video
(DV-600AV only)
or SCART cable for the
video connection.
2
Connect the supplied AC power cable
to the AC IN inlet, then plug into a power
outlet.
Note
• Before unplugging the player from the
power outlet, make sure you first switch it
into standby using either the front panel
STANDBY/ON
button, or the remote
control, and wait of the
-OFF-
message to
disappear from the player’s display.
• For the above reasons, do not plug this
player into a switched power supply found
on some amplifiers and AV receivers.
P
R
P
B
Y
COMPONENT VIDEO OUT
AV CONNECTOR (RGB) TV/AV Receiver
VIDEO OUT
AC IN
S-VIDEO OUT
AUDIO OUT (5.1ch)
DIGITAL AUDIO OUT
OPTICAL
SL
SR
HDMI OUT
SW
C
L
R
COAXIAL
To audio/video inputs
To power outlet
Yellow
White
Red
TV
DV-600AV
DV600AV_UK_EN.book 11 ページ 2007年3月16日 金曜日 午後2時31分