Getting started
04
20
En
2
Connect (a) microphone(s) (not
supplied) to the MIC input jack.
Make sure that the plug of the microphone is
inserted firmly and completely into the jack.
3
Load a disc with the music you want to
use.
4
Play the title, chapter or track and
adjust the volume of the audio playback.
• For more information on loading a disc and
playing back a title, chapter or track, refer
to the section
Playing discs
on page 22.
• Adjust the volume on the TV or component
that audio connections are made to.
VOLUME
on the front panel controls only
the level of the microphone(s).
5
When the music starts, turn VOLUME
clockwise while speaking or singing into
the microphone to adjust the vocal volume
to an appropriate level.
6
Turn ECHO clockwise to adjust the
amount of echo effect that you want
added to the vocals.
The amount of echo effect needed may differ
for different styles of music and for different
preferences.
7
Adjusting the music to suit your voice
Use the key control on the remote control to
match the backing music to your vocal range.
• Press
(HIGH) repeatedly to raise the
pitch of the backing music.
• Press
(LOW) repeatedly to lower the
pitch of the backing music.
Note
• You can adjust the HIGH tone in a range of
five steps and the LOW tone in a range of
five steps.
• If the microphone level is too high, the
sound may distort. In this case, lower the
volume.
When “howling” occurs
If sound from the speakers is picked up by a
mic and output again through the speakers,
the result is a screeching sound known as
“howling”.
To eliminate howling:
• Point the mic away from the speakers.
• Move the mic away from the speakers.
• Turn
VOLUME
counterclockwise to lower
the volume level.
• Turn
ECHO
counterclockwise to lower the
echo effect.
Note
• Reduce the volume when plugging in the
microphone to prevent feedback.
STANDBY/ON
OPEN/CLOSE
FL DIMMER
STANDBY/ON
ECHO
VOLUME
MIC 2
MIC 1
MIN-MAX
MIN-MAX
DV575K_KARAOKE.book 20 ページ ２００４年２月２６日 木曜日 午後５時１８分
