4
En
Important
•
Avoid subjecting the front panel to excessive shock.
•
Keep the front panel out of direct sunlight and high temperatures.
•
Always store the detached front panel in a protective case or bag.
Remove the insulation sheet before use.
WARNING
•
Keep the battery out of the reach of children. Should the battery be swallowed, consult a doctor
immediately.
•
Do not expose the battery or remote control to excessive heat such as direct sunlight or fire.
CAUTION
•
There is a potential danger of explosion if the battery is incorrectly replaced. When replacing the
battery, replace it with the same type.
•
Do not handle or store the battery with metallic tools or objects.
•
If the battery leaks, remove the battery and wipe the remote control completely clean. Then install a
new battery.
•
When disposing of used batteries, please comply with governmental regulations or environmental
public institutions’ rules that apply in your country/area.
Preparing the remote control
Detach
Attach
How to replace the battery
Insert the CR2025 (3 V) battery with the plus (+) and
minus (–) poles orientated properly.
Important
•
Do not store the remote control in high temperatures or direct sunlight.
•
Do not let the remote control fall onto the floor, where it may become jammed under the brake or
accelerator pedal.
When you turn the ignition switch to ON after installation, [SET UP :YES] appears in the
display.
1
Press the
M.C.
dial.
The setup menu disappears after 30 seconds of no operation. If you prefer not to set
at this time, turn the
M.C.
dial to select [NO], then press to confirm.
2
Turn the
M.C.
dial to select the options, then press to confirm.
To proceed to the next menu option, you need to confirm your selection.
3
[QUIT :YES] appears when all the settings have been made.
To return to the first item of the setup menu, turn the
M.C.
dial to select [QUIT :NO],
then press to confirm.
4
Press the
M.C.
dial to confirm the settings.
NOTES
•
You can cancel the menu setting by pressing
SRC
/
OFF
.
•
These settings can be made at any time from the SYSTEM settings (page 9) and INITIAL settings
(page 5).
1
Press the
M.C.
dial to display the main menu.
2
Turn the
M.C.
dial to select [SYSTEM], then press to confirm.
3
Turn the
M.C.
dial to select [DEMO OFF], then press to confirm.
4
Turn the
M.C.
dial to select [YES], then press to confirm.
Setup menu
Menu Item
Description
CLOCK SET
Set the clock.
FM STEP
Select the FM tuning step from 100 kHz or 50 kHz.
[100], [50]
AM STEP
Select the AM tuning step from 10 kHz or 9 kHz.
[10], [9]
Canceling the demonstration display (DEMO OFF)
