9
En
En
g
lis
h
*1 Not available when [SUB.W/SUB.W] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*2 Not available when [REAR/REAR] is selected in [SP-P/O MODE] in the INITIAL settings (page 5).
*3 Not available when [OFF] is selected in [SUB.W].
You can also access to these menus when the unit is turned off.
LOUDNESS
[OFF], [LOW], [MID], [HI]
Compensate for clear sound at low volume.
SUB.W
*2
[NOR], [REV], [OFF]
Select the subwoofer phase.
SUB.W CTRL
*2*3
Cut-off frequency:
[50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Output level:
[–24] to [+6]
Slope level:
[–12], [–24]
Only frequencies lower than those in the
selected range are output from the subwoofer.
BASS BOOST
[0] to [+6]
Select the bass boost level.
HPF SETTING
Cut-off frequency:
[OFF], [50HZ],
[63HZ], [80HZ], [100HZ], [125HZ],
[160HZ], [200HZ]
Slope level:
[–12], [–24]
Only frequencies higher than the high-pass filter
(HPF) cutoff are output from the speakers.
SLA
[+4] to [–4]
Adjust the volume level for each source except
FM.
SYSTEM settings
Menu Item
Description
CLOCK SET
Set the clock (page 4).
12H/24H
[12H], [24H]
Select the time notation.
AUTO PI
[ON], [OFF]
Search for a different station with the same
programming, even if using a preset station.
Menu Item
Description
*1 Depending on your car, this function may not work properly. In this case, contact your dealer or an
authorized PIONEER Service Station.
*2 Please use a commercially available wiring harness for each car model when [PRESET] mode is
engaged, and use a commercially available adapter when in [PIONEER].
AUX
[ON], [OFF]
Set to [ON] when using an auxiliary device
connected to the unit.
USB AUTO
[ON], [OFF]
Select [ON] to automatically switch to [USB]
source when a USB device is connected to the
unit.
Select [OFF] when a USB device is being
connected to the unit just for charging.
ANDROID WIRED
[MEMORY], [APP CONTROL]
Select the appropriate connection method for an
Android device.
P.APP AUTO ON
[ON], [OFF]
Select [ON] to automatically launch the car remote
application when an Android device is connected
to the unit via AOA. (Not available when
[MEMORY] is selected in [ANDROID WIRED].)
S.REMOTE
*1*2
[OFF], [PIONEER], [PRESET]
Select [PIONEER] or [PRESET] according to your
wired remote control.
ILLUMINATION settings
Menu Item
Description
DIM SETTING
[SYNC CLOCK], [MANUAL]
Change the display brightness.
BRIGHTNESS
[1] to [10]
Change the display brightness.
The available setting ranges differ depending on
[DIM SETTING].
Menu Item
Description
