PRO-1010HD
92
1
2
3
4
1
2
3
4
C
D
F
A
B
E
6. ADJUSTMENT
6.1
ADJUSTMENT REQUIRED WHEN THE SET IS REPAIRED OR REPLACED
1. At shipment, the unit is adjusted to its best conditions. Normally, it is not necessary to readjust even if an assembly is replaced. If the
adjustment is shifted or if it becomes necessary to readjust because of part replacement, etc., perform the adjustment as described below.
2. Any value changed in Service/Factory mode will be stored in memory as soon as it is changed. Before readjustment, take note of the
original values for reference in case you need to restore the original settings.
3. Use a stable AC power supply.
50 Y DRIVE Assy
No adjustment required
AV I/O Assy
No adjustment required
RGB Assy
No adjustment required
POWER SUPPLY Unit
No adjustment required
DIGITAL VIDEO Assy
Copy of backup data requires.
• When adjust with the service factory mode, refer to
"10.DIGITAL EEPROM" of "6.2 SERVICE FACTORY MODE."
• When adjust with the command, refert to "7.1.6 BACKUP
THE ADJUSTMENT VALUES FOR THE MAIN UNIT."
50 X DRIVE Assy
No adjustment required
VIDEO SLOT Assy
Other assemblies
No adjustment required
No adjustment required
Service Panel
Refer to "6.4 METHOD FOR REPLACING THE SERVICE
PANEL ASSY."
POWER SUPPLY Unit
DIGITAL VIDEO Assy
No adjustment required
50 X DRIVE Assy
No adjustment required
50 Y DRIVE Assy
No adjustment required
Replacement and repair of IC6803, IC6810, IC7610 and
IC8705 are impossible.
AV I/O Assy
RGB Assy
Replacement and repair of IC6001, IC6401, IC6403,
IC6601, IC6602 and IC7205 are impossible.
Replacement and repair of IC6107, IC6255, IC6257
and IC7902 are impossible.
VIDEO SLOT Assy
Other assemblies
No adjustment required
When any of the following assemblies is replaced
When any part in the following assemblies is replaced
The assembly must be replaced as a unit, and no part
replacement is allowed.
