PRO-730HDI
99
5
6
7
8
5
6
7
8
C
D
F
A
B
E
2
Deflection Yoke Lean Adjustment
2
Deflection Yoke Adjustment
Start
Cross hatch
Centering magnet
(Turn in either direction until cross signal
becomes white.)
Deflection
yoke
Centering magnet
(Turn in either direction until cross signal becomes white.)
Deflection
yoke
• Move the centering magnet of the deflection yoke for the
replaced color so that the horizontal and vertical lines at the
center of the screen align with the lines for a color not replaced.
• Apply an adhesive between the neck part of CRT and centering
magnet so that the centering magnet of the deflection yoke does
not move.
2
Screen Center Adjustment
Start
Cross hatch
-1
-2
• Turn the deflection yoke of the replaced CRT so that the cross
hatch of the color corresponding to the replaced CRT converges
with that of the CRTs not replaced.
• When a CRT is replaced, check the position of the VM (Velocity
Modulation) yoke.
Turn to adjust.
• Input a stable signal (e.g. from an DVD / LD player or SG) to
the INPUT 1 connector.
• MENU
→
SETUP
→
CONVERGENCE
→
ADJUSTMENT FOR 480P
→
ADJ MULTI-POINT
• The cross hatch disappears if there is no operation with
the remote control unit for about 8 minutes. If the cross
hatch disappears, repeat the above operation with the
remote control unit or main unit key.
0 mm
0 mm
B CRT
DRIVE Assy
CRT SERVICE
Assy B
CRT SERVICE
Assy G
CRT SERVICE
Assy R
G CRT
DRIVE Assy
R CRT
DRIVE Assy
Deflection
Yoke (B)
Deflection
Yoke (G)
Deflection
Yoke (R)