15
QUICK ST
AR
T GUIDE
Quick Start Guide Part2
2
2
2
2
2
Playing a DVD with Surround Sound
1
Make sure the receiver, your TV, and your DVD player are switched ON.
2
Press the DVD/LD button on the remote control.
You should see "DVD/LD" in the display on the receiver.
3
Press the LISTENING CH SELECT button on the remote control
repeatedly until you
see "7.1" in the display on the receiver.
4
Press the STANDARD button on the remote control for the basic
surround sound setting.
5
Play a DVD then adjust the MASTER VOLUME.
3
3
3
3
3
Personalizing Your Sound
1
Use the Surround Listening Mode buttons to find the listening mode(s)
that work best for the source material.
For more information see pages 46–49.
2
To get a more refined sound, make the sound settings in "Expert
Setup" (p.90-95).
memo
Use the
∞5
buttons to select OK,
GO NEXT and press ENTER. Put the
remote control into the its stand.
The system will output another series of test tones to
establish the proper channel level, channel delay and
acoustic calibration EQ. Again, be prepared for loud
test tones.
After it has finished, you see the SPEAKER
SYSTEMS CHECK screen. If you want to view the
settings select
NEXT
and press
ENTER
repeatedly.
If not, simply go to the next step.
13
Select RETURN to go back to the
SYSTEM SETUP menu, then choose
EXIT to complete the auto surround
sound setup and return to normal
use.
You should now have settings that will give you
good surround sound. The MCACC indicator will
light and the surround sound settings are com-
plete.
• Make sure the room environment follows the
guidelines displayed on the OSD during auto
setup. If the room environment is not optimal
for auto setup (too much ambient noise,
obstacles blocking the speakers from the
microphone on the remote control, etc.) the
final settings may be incorrect. Check for
household appliances (air conditioner, fridge,
fan, etc.) that may be affecting the
environment and switch them off if necessary.
• Screens will turn off after three minutes and
the receiver will automatically exit from the
setup process.
• If you leave CHECK!! or other error message
on the screen for three minutes, or you
choose CANCEL at anytime during the setup,
the settings made up to that point will be
cleared.
• After completing the Auto Surround Sound
Setup, ACOUSTIC CAL EQ ON (ALL CH ADJ)
is set automatically.