Before installing the amplifier
WARNING
!
To ensure proper installation, use the supplied
parts in the manner specified. If any parts
other than those supplied are used, they may
damage internal parts of the amplifier, or be-
come loose causing the amplifier to shut
down.
!
Do not install in:
—
Places where it could injure the driver or
passengers if the vehicle stops suddenly.
—
Places where it may interfere with the dri-
ver, such as on the floor in front of the dri-
ver
’
s seat.
!
Install tapping screws in such a way that the
screw tip does not touch any wire. This is im-
portant to prevent wires from being cut by vi-
bration of the car, which can result in fire.
!
Make sure that wires do not get caught in the
sliding mechanism of the seats or touch the
legs of a person in the vehicle as short-circuit
may result.
!
When drilling to install the amplifier, always
confirm no parts are behind the panel and
protect all cables and important equipment
(e.g. fuel/brake lines, wiring) from damage.
CAUTION
!
To ensure proper heat dissipation of the ampli-
fier, ensure the following during installation:
—
Allow adequate space above the amplifier
for proper ventilation.
—
Do not cover the amplifier with a floor mat
or carpet.
!
Place all cables away from hot places, such
as near the heater outlet.
!
The optimal installation location differs de-
pending on the car model. Secure the ampli-
fier at a sufficiently rigid location.
!
Check all connections and systems before
final installation.
!
After installing the amplifier, confirm that the
spare tire, jack and tools can be easily re-
moved.
Attaching the Bass boost
remote control
Attach with tapping screws (3 mm × 10 mm)
at an easily accessible location such as under
the dashboard.
Tapping screws (3 mm × 10 mm)
Example of installation on
the floor mat or chassis
1
Place the amplifier in the desired instal-
lation location.
Insert the supplied tapping screws (4 mm ×
18 mm) into the screw holes and push on the
screws with a screwdriver so they make an im-
print where the installation holes are to be lo-
cated.
2
Drill 2.5 mm diameter holes at the im-
prints either on the carpet or directly on
the chassis.
En
12
Section
04
Installation
Summary of Contents for GM-D8604
Page 43: ...Ptbr 43 Português B ...
