En(9/10)
Installation
Before installing the
@LOKHÆDQ
WARNING
To ensure proper installation, use the sup-
plied parts in the manner specified. If any
parts other than those supplied are used, they
may damage internal parts of the amplifier or
become loose, causing the amplifier to shut
down.
Do not install:
—
On surfaces that could become loose
if the boat stops suddenly (chassis
recommended).
—
In places where it may interfere with the
boat’s operation.
Install tapping screws in such a way that the
screw tip does not touch any wire. This is
important to prevent wires from being cut by
vibration of the boat, which can result in fire.
Make sure that wires do not get caught in
the sliding mechanism or touch the legs of a
person in the boat as short-circuit may result.
CAUTION
Place all cables away from hot places, such
as near the heater outlet.
The optimal installation location differs
depending on the boat model. Secure the
amplifier at a sufficiently rigid location.
Check all connections and systems before
final installation.
Example of installation on
the chassis
Ä Ä/K@BDÄSGDÄ@LOKH×DQÄHMÄSGDÄCDRHQDCÄ
installation location.
Insert the supplied tapping screws (4 mm
× 25 mm) into the screw holes and push
on the screws with a screwdriver so they
make an imprint where the installation
holes are to be located.
2
Drill 2.5 mm (1/8 in.) diameter holes in
SGDÄLNTMSHMFÄRTQE@BD
Ä Ä(MRS@KKÄSGDÄ@LOKH×DQÄVHSGÄSGDÄTRDÄNEÄ
RTOOKHDCÄS@OOHMFÄRBQDVRÄÄLLÄÐÄÄ
mm).
1
②
4
3
1
Tapping-screws (4 mm × 25 mm) (5/32 in.
× 1 in.)
2
Installation surface
3
Hole-to-hole distance: 224.4 mm (8-27/32 in.)
4
Hole-to-hole distance: 86.4 mm (3-13/32 in.)
4
Attach the top panel cover.
Use the removed screws to attach the top
panel cover (fastening torque 0.4 to 0.7
N·m).
Attach the top panel cover in the same
orientation as the main unit installation
orientation.
1
2
1
Screws
2
Top panel cover
