52
HTP-071
1
2
3
4
A
B
C
D
E
F
1
2
3
4
End the application EPFlash.
Select "VSX-321_LPP_********.hex" file to update MCU.
Rate of the progression is appeared.
When the PC and the Upgrade Jig
are connecting, the COM PORT is
set automatically.
Set Baud rate to 57600.
for CEC microcomputer
If the following messages are displayed, shut the update
program down, and start the update again from step 8.
11. Select the update file. Press the "OpenFile" button.
12. Press the "START" button to update the firmware.
14. Turn the unit off (STA
N
DBY mode) and unplug the
AC
cord.
Disconnect the FFC cable.
15. Unplug the AC cord.
Start up the application EPConsole on the PC.
16. Select "CEC UP" on the Upgrade Jig.
Connect the PC and the Upgrade Jig.
Connect the FFC cable. (CEC microcomputer )
Plug the AC cord. (STA
N
DBY mode)
13. Update Finished HDMI microcomputer.
Summary of Contents for HTP-071
Page 9: ...9 HTP 071 5 6 7 8 5 6 7 8 A B C D E F ...
Page 12: ...12 HTP 071 1 2 3 4 A B C D E F 1 2 3 4 4 2 OVERALL BLOCK DIAGRAM H FRONT ASSY A INPUT ASSY ...
Page 89: ...89 HTP 071 5 6 7 8 5 6 7 8 A B C D E F C SIDE B CP1 CP3 CP5 CN1 CN3 ...
Page 93: ...93 HTP 071 5 6 7 8 5 6 7 8 A B C D E F D SIDE B CN600 CP104 ...