06
06
Home menu
31
En
English
ϜН
Español
Adjust the level of each speaker as the test tone is emitted.
Note
• If you are using a Sound Pressure Level (SPL) meter, take
the readings from your main listening position and adjust
the level of each speaker to 75 dB SPL (C-weighting/slow
reading).
• The subwoofer test tone is output at low volumes. You
may need to adjust the level after testing with an actual
soundtrack.
6
When you’re finished, press RETURN.
You return to the Manual SP Setup menu.
Tip
• You can change the channel levels at any time by press
, then press
CH SELECT
and
LEV +/–
on the
remote control. You can also press
CH SELECT
and use
/
to select the channel, and then use
/
to adjust
the channel levels.
Speaker Distance
For good sound depth and separation from your system, you
need to specify the distance of your speakers from the
listening position. The receiver can then add the proper delay
needed for effective surround sound.
• For the assignment of the digital signal inputs, see
Selecting the audio input signal
on page 20.
1
Select ‘Manual SP Setup’ from the Home Menu.
2
Select ‘Speaker Distance’ from the Manual SP Setup
menu.
3
Adjust the distance of each speaker Using
/
.
You can adjust the distance of each speaker in 0.1 m
increments.
4
When you’re finished, press RETURN.
You return to the Manual SP Setup menu.
The Input Assign menu
ANALOG IN1
audio input terminal is assigned to
CD
under
factory settings, but this can be changed to
TV
input.
1
Select ‘Input Assign’ from the Home Menu.
2
Select ‘Analog Input’ from the Input Assign menu.
3
Select the desired input option for the ANALOG IN1
audio input terminal.
4
When you’re finished, press RETURN.
You return to the Input Assign menu.
The Auto Power Down menu
Set to automatically turn off the receiver after a specified time
has passed (when the power has been on with no operation
for several hours).
• Default setting:
OFF
1
Select ‘Auto Power Down’ from the Home Menu.
2
Specify the amount of time to allow before the power
is turned off (when there has been no operation).
• You can select 2, 4 or 6 hours, or
OFF
(if no automatic
shutoff is desired).
3
When you’re finished, press RETURN.
You return to the Home menu.
RECEIVER
1.Manual SP Setup
Return
a.Speaker Setting
b.X.Over
c.Channel Level
d.Speaker Distance
1d.Speaker Distance
Front L
Center
Front R
Surround R
Surround L
Subwoofer
Return
[ 3.0 m ]
[ 3.0 m ]
[ 3.0 m ]
[ 3.0 m ]
[ 3.0 m ]
3.0 m
H o m e M e nu
1 . Manual SP Setup
2.Input Assign
3.Auto Power Down
4.HDMI Setup
R e t u r n
2.Input Assign
Return
a.Analog Input
2a.Analog Input
Return
Analog
CD
H o m e M e nu
1 . Manual SP Setup
2.Input Assign
3.Auto Power Down
4.HDMI Setup
R e t u r n
3.Auto Power Down
Return
OFF
Auto Power Down
VSX-324-K-P_DLXE.book 31 ページ ２０１３年３月２１日 木曜日 午前９時１７分
