3
STANDARD SURROUND SETUP
This is a standard multichannel surround sound speaker setup
for optimal 5.1 channel home theater sound.
NON-SKID PADS
If the front, center and surround speakers are placed on a hard
surface, such as wood or tile place four non-skid pads (small)
on the bottom flat surface of the speakers.
If the subwoofer is placed on a hard floor, such as wood or tile,
place four non-skid pads (large) on the bottom surface of the
subwoofer.
Front left
Surround
left
Listening position
Center
Subwoofer
Front right
Surround
right
CABINET MAINTENANCE
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the cabinet is very dirty, clean with a soft cloth dipped in
some neutral cleanser diluted five or six times with water, and
then wipe again with a dry cloth. Do not use furniture wax or
cleaners.
Never use thinners, benzine, insecticide sprays and other
chemicals on or near the cabinets, since these will corrode the
surfaces.
WALL-MOUNTING THE FRONT, CENTER
AND SURROUND SPEAKER SYSTEM
Before mounting
• Remember that the speaker system is heavy and that its weight
could cause the screws to work loose, or the wall material to
fail to support it, resulting in the speaker falling. Make sure
that the wall you intend to mount the speakers on is strong
enough to support them. Do not mount on plywood or soft
surface walls.
• Mounting screws are not supplied. Use screws suitable for
the wall material and support the weight of the speaker.
NOTE
• If you are unsure of the quality and strength of the walls, consult
a professional for advice.
• Pioneer is not responsible for any accidents or damage that
result from improper installation.
3/16 in. to 1/4 in.
(5 mm to 7 mm)
3/16 in.
(5 mm)
3/8 in.
(10 mm)
Mounting screw
(not supplied)
