HTZ-7, HTZ-C7, HTZ-SW7, HTZ-ST7
118
Function
Initial Value
Adjustment Range
VOLUME
0
0 to 35
BASS
0
–6 to +6
TREBLE
0
–6 to +6
FRONT L LEVEL
0
–10dB to +10dB
FRONT R LEVEL
0
–10dB to +10dB
REAR L LEVEL
0
–10dB to +10dB
REAR R LEVEL
0
–10dB to +10dB
SUB WOOFER LEVEL
0
–10dB to +10dB
CENTER LEVEL
0
–10dB to +10dB
REAR L DELAY
0
0, 5, 10, 15 ms (15, 20, 25, 30 ms with Prologic)
REAR R DELAY
0
0, 5, 10, 15 ms (15, 20, 25, 30 ms with Prologic)
CENTER DELAY
0
0, 1, 2, 3, 4, 5 ms
MIDNIGHT
OFF
ON/OFF
DSP MODE
OFF
GAME, SPORT, MUSIC, MOVIE
ONE-TOUCH SURROUND
CENTER
FRONT +2 to REAR +2
DOLBY PRO-LOGIC
OFF
ON/OFF
Initial values of the set values for each mode and their adjustment ranges
Shown in Fig. 2.
Fig. 2
Initial Values for Each Mode
(Setting to the above initial values has been done at the time of power ON.)
1. Test Mode Use Conditions
Use of the test mode with connected DVD center unit is not
possible. In that case, do not use test mode, but normal operation.
When there is a display unit
When there is a display unit, use is possible simply by connection
to an outlet.
When there is no display unit
The remote control light reception jig (GGF1270) must be connected.
Display at the time of operation is not possible.
Powered Subwoofer (HTZ-SW7)
2. How to enter into test mode
With connection to an outlet and a display unit (or the remote
control light reception jig), the power will be switched on and SF
controller test mode will be entered when “ESC+TEST” is
transmitted from the test mode remote control for LD servicing.
Display during test mode
After power ON, all FL are lit. Afterwards, TEST MODE is
displayed except at the time of operation. The display at the time of
operation is the same as during normal operation.
How to leave test mode
When “ESC” is transmitted from the test mode remote control for
LD servicing (GGF1067), the power is switched off. The same
effect can be obtained when the plug is pulled from the outlet.
Operation during test mode
During test mode, all operations can be performed with the test
remote control for LD servicing (GGF1067). The operation is
shown in Fig. 3.
