Adjusting initial settings
1
Initial settings lets you perform initial set up of
different settings for this unit.
1
Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press FUNCTION and hold until the
clock appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press
FUNCTION
repeatedly to switch be-
tween the following settings:
Clock
FM Step
(FM tuning step)
AM Step
(AM tuning step)
Warning
(warning tone)
AUX
(auxiliary input)
Dimmer
(dimmer)
Brightness
(brightness)
Rear SP
(rear out-
put and subwoofer controller)
Telephone
(telephone)
Use the following instructions to operate each
particular setting.
#
To cancel initial settings, press
BAND
.
#
You can also cancel initial settings by holding
down
FUNCTION
until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press
FUNCTION
repeatedly until clock ap-
pears in the display.
2 Press
c
or
d
to select the segment of
the clock display you wish to set.
Pressing
c
or
d
will select one segment of the
clock display:
Hour
Minute
As you select segments of the clock display
the segment selected will blink.
3 Press
a
or
b
to set the clock.
Pressing
a
will increase the selected hour or
minute. Pressing
b
will decrease the selected
hour or minute.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press FUNCTION to select FM Step.
Press
FUNCTION
repeatedly until
FM Step
ap-
pears in the display.
2 Press
c
or
d
to select the FM tuning
step.
Pressing
c
or
d
will switch the FM tuning
step between 100 kHz and 50 kHz. The se-
lected FM tuning step will appear in the dis-
play.
Note
If seek tuning is performed in 50 kHz steps, sta-
tions may be tuned in imprecisely. Tune in the sta-
tions with manual tuning or use seek tuning
again.
Initial Settings
En
29
English
Section
08
HHHHHHHHHHHHHH
