Setting the rear output and
subwoofer controller
This unit
s rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (
Rear SP :FULL
) or subwoofer
(
Rear SP :S.W
) connection. If you switch the
rear output setting to the
Rear SP :S.W
, you
can connect a rear speaker lead directly to a
subwoofer without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (
Rear SP :FULL
). When rear out-
put are connected to full range speakers
(when
Rear SP :FULL
is selected), you can
connect the RCA subwoofer output to a sub-
woofer. In this case, you can select whether to
use the subwoofer controller
s (low pass filter,
phase) built-in
S.W Control:INT
or the auxili-
ary
S.W Control:EXT
.
1 Press FUNCTION to select Rear SP.
Press
FUNCTION
repeatedly until
Rear SP
ap-
pears in the display.
2 Press
a
or
b
to switch the rear output
setting.
Pressing
a
or
b
will switch between
Rear SP :FULL
(full-range speaker) and
Rear SP :S.W
(subwoofer) and that status will
be displayed.
#
When no subwoofer is connected to the rear
output, select
Rear SP :FULL
.
#
When a subwoofer is connected to the rear
output, set for subwoofer
Rear SP :S.W
.
#
When the rear output setting is
Rear SP :S.W
,
you cannot change the subwoofer controller.
3 Press
c
or
d
to switch the subwoofer
output or non fading output (full-range
RCA output).
Pressing
c
or
d
will switch between
S.W Control:INT
and
S.W Control:EXT
and
that status will be displayed.
Notes
!
Even if you change this setting, there is no
output unless you turn the non fading output
(refer to
Using non fading output
on page 27)
or subwoofer output (refer to
Using subwoofer
output
on page 26) in the audio menu on.
!
If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
!
Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting.
Switching the telephone
muting/attenuation
Sound from this system is muted or attenu-
ated automatically when a call is made or re-
ceived using a cellular telephone connected to
this unit.
!
The sound is turned off,
MUTE
or
ATT
is
displayed and no audio adjustment is pos-
sible.
!
Operation returns to normal when the
phone connection is ended.
1 Press FUNCTION to select Telephone.
Press
FUNCTION
repeatedly until
Telephone
appears in the display.
2 Press
c
or
d
to switch the telephone
muting/attenuation.
Pressing
c
or
d
will switch between
Telephone :ATT
(attenuation) and
Telephone :MUTE
(muting) and that status
will be displayed.
Initial Settings
En
31
English
Section
08
HHHHHHHHHHHHHH
