13
En
Installation Procedure
3
Hang the hooks at the top of the display
side fittings to the wall side fittings (two
locations).
Attach the Pioneer display and television so that it aligns
with the guide labels. Check that the top hooks are
firmly hung and that the Pioneer display and television is
attached in its correct position and is level.
Hang the hooks at the top of the display side
fittings to the wall side fittings, pass a wire in
each spring hook, and attach it to the eye plate
(or eye bolt) attached to the wall.
Attach the wire after
temporarily attaching it to
the rear case with tape, etc.
Fix the wire to the eye
plate (or eye bolt).
Spring hook
Caution
In the case of a 60-inch display, always
have three or more persons on hand when
installing the display. In the case of a 50-inch
display, have two or more persons on hand.
Ìi
• If speakers are attached, do not hold the speakers
when performing this attachment.
• Make sure that the wiring, etc., does not get caught in
the fittings or the Pioneer display and television.
• Do not forcefully pull down the bottom of the Pioneer
display and television when the display side fittings
hang from the wall side fittings because this may
cause the top part of the Pioneer display and television
to touch the wall, resulting in scratches or damage.
4
Adjust the Pioneer display and television
position.
The position of the Pioneer display and television can be
fine-adjusted horizontally and vertically.
Pioneer display and television
Wall mount unit
5
Fix the fittings with the fall-prevention
screws (two locations).
Tighten the two fall-prevention screws of the display side
fittings all the way.
Fall-prevention screws
Pioneer display and television
After fixing the fittings, remove the guide labels and the
fall prevention caution tag.
Caution
Be sure to tighten the fall-prevention screws
to securely fix the display side fittings and
the wall side fittings.
Ìi
When removing the fall-prevention caution tag, be careful
not to cut your fingers.
