Setting up
08
31
En
E
n
glish
Setting up analogue TV channels
manually
Use the Manual Adjust function to set up analogue TV channels
manually.
1
Press HOME MENU.
2
Select “Setup” (
/
then ENTER).
3
Select “System Setup” (
/
then ENTER).
4
Select “Analogue TV Setup” (
/
then ENTER).
The password entry screen appears. Enter your four-digit password
using buttons
0
to
9
. For the password, see
5
Select “Manual Adjust” (
/
then ENTER).
6
Select “Programme Entry” (
/
).
7
Select a programme number (
/
).
You can select 1 through 99.
8
Select “Search” (
/
).
9
Enter a frequency using buttons 0 to 9, then ENTER.
You can also press
/
to enter a frequency.
10 Select “System” (
/
).
11 Select a sound system (
/
).
You can select from among “B/G”, “D/K”, “I”, “L”, and “ L’ ”.
12 Select “Colour System” (
/
).
13 Select a colour system (
/
).
You can select from among “Auto”, “PAL”, “SECAM”, and “4.43NTSC”.
14 Select “Store” (
/
).
15 Select “Yes” or “No” (
/
).
16 Press HOME MENU to exit the menu.
Alternatively, to set up for another channel, repeat steps 7 to 15.
Note
• The above procedure transfers and sets the selected channel
information to the connected recording equipment such as a
VCR or DVD/HDD recorder (DVR).
• Manual Adjust also allows you to make selections for “Tuner
NR”, “Channel Lock”, and “Decoder”. See
Reducing video noise
,
Setting Channel Lock
, and
Selecting a decoder input terminal
.
Reducing video noise
For the individual channels, you can specify whether the flat screen
TV should reduce video noise depending on the levels of
broadcasting signals.
1
Repeat steps 1 to 5 provided for
Setting up analogue TV
channels manually.
2
Select “Tuner NR” (
/
).
3
Select “On” (
/
).
4
Press HOME MENU to exit the menu.
Note
• This function may not achieve a satisfactory result, depending on
the conditions of broadcasting signals.
• When using a decoder with a decoder terminal selected, this
function may fail to achieve a good result.
• The factory default is “On”.
Setting Channel Lock
Channel Lock inhibits selected TV channels from being tuned and
watched.
1
Repeat steps 1 to 7 provided for
Setting up analogue TV
channels manually.
After selecting a channel (using Programme Entry), perform the
following steps:
2
Select “Channel Lock” (
/
).
3
Select “Block” (
/
).
The selection is switched between “View” (factory default) and
“Block”.
4
Press HOME MENU to exit the menu.
Item
Description
Yes
You can select the channel using
P+
/
P–
No
You cannot select the channel using
P+
/
P–
Manual Adjust
Label
Sort
PDP-LX609H.book Page 31 Wednesday, August 6, 2008 4:00 PM
