Black plate (25,1)
<CRD3740-A>25
1 Press AUDIO to select F-HPF or R-HPF.
Press
AUDIO
until
F-HPF
or
R-HPF
appears in
the display.
2 Press
a
to turn high pass filter on.
F-HPF: 80
or
R-HPF: 80
appears in the display.
High pass filter is now on.
#
To turn high pass filter off, press
b
.
3 Press
c
or
d
to select cut-off frequency.
Each press of
c
or
d
selects cut-off frequen-
cies in the following order:
50
63
80
100
125
(Hz)
Only frequencies higher than those in the se-
lected range are output from the front or rear
speakers.
Adjusting high pass filter
attenuation slope
When the high pass filter is on, you can adjust
the continuity of sound between speaker
units.
1 Press AUDIO to select the slope setting.
Press
AUDIO
until
F-SLP
or
R-SLP
appears in
the display.
2 Press
c
or
d
to select slope.
Press
c
and
12
is displayed. Press
d
and
6
is
displayed.
Using non fading output
When the non fading output setting is on, the
audio signal does not pass through this unit
s
low pass filter (for the subwoofer), but is out-
put through the RCA output. For more details,
see
Switching the RCA output setting
on page
32.
1 Press AUDIO to select NoFAD.
When the RCA output setting is
P/O :FUL
, you
can select
NoFAD
. Press
AUDIO
until
NoFAD
appears in the display.
2 Press
a
to turn non fading output on.
NoFAD:ON
appears in the display. Non fading
output is now on.
#
To turn non fading output off, press
b
.
Adjusting non fading output level
When the non fading output is on, you can ad-
just the level of non fading output.
1 Press AUDIO to select non fading out-
put setting.
Press
AUDIO
until
NoFAD: 0
appears in the
display.
2 Press
a
or
b
to adjust the level of the
non fading output.
Each press of
a
or
b
increases or decreases
the level of the non fading output (e.g.,
+ 6
24
).
Press
a
or
b
until you see the desired value
displayed.
Audio Adjustments
En
25
English
Section
07
HHHHHHHHHHHHHH
Summary of Contents for MEH-P6550
Page 78: ...Ptbr 78 HHHHHHHHHHHHHH ...
